Inhoudsopgave
Advertenties
SECTION 5
Fig. 5-30 "0" Ring Installation
3. To keep out dirt during installation, cover the motor
manifold mounting pad and seals with a piece of card·
board and hold with a piece of wire.
After transaxle installation, cut retaining wire and
remove cardboard. Lift manifold to make sure seals
are still in place.
Fig. 5·31 Mounting Pad Cover
4. Place transaxle squarely in the jack, and jack the unit up
into place. Prevent binding between the front plate and
the angle brackets.
5-10
Fig. 5·32 Raising Transaxle
5. Start the top four case bolts using a punch for align·
ment. Leave them slightly loose at this time.
Fig. 5·33 Transaxle Top Bolts
6. Align the front case holes with the butt plate using a
punch.
7. Install the four front bolts and washers, making sure the
transaxle is squarely against both plates.
8. Tighten all eight bolts.
9. Install the axle links or hitch as applicable.
10. Connect the brake rod to the brake band.
11. Install the dipstick and tube assembly.
Advertenties
Inhoudsopgave
