Inhoudsopgave
Advertenties
1. Disconnect and remove battery.
2. Remove left side access plate.
3. Disconnect two hoses and four metal tubular lines from
valve assembly.
Note connections for reinstallation.
4. Remove park brake knob, spring, and washer.
5. Remove two bolts at right side of parking brake guide
plate, and remove plate with hydraulic valve attached.
6. Remove three bolts securing valve body to parking
brake guide plate.
After reassembling, check transaxle oil level after running
the engine and operating the lift system for one (1) minute.
Remove Hydraulic Valve Handle
1. Disconnect battery ground cable.
2. Remove switch nut from I ight switch. On D-160, also
remove switch nut from
PTO
switch.
3. Remove top and two outside screws from lower instru-
ment panel. Swing panel out of the way.
4. Remove nut and clevis pin from valve handle.
5. Slide handle off "S" link.
6. Replace handle using new push nut supplied with new
handle.
NOTES
Overhaul Hydraulic Valve
Same procedure as C-Series.
Remove Hydraulic Hoses
1. Remove battery.
SECTION 7
2. Remove left side access plate, and access cover plate
located over hydraulic cylinder.
3. Remove hoses at cylinder and valve assembly. See Fig.
7-9.
After reassembling, check transaxle oil level after running
the engine and operating the lift system for one (1) minute.
C-161 TWIN
Same as C-Series
- - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - -
- - - -
- - - - - - - - - - - - - - - - - - - - -
- - -
- - - -
- - - - - - - - -
- - - - - - - - - - - - - - - - - - - - -
- - -
- - - - - - - - -
7-5
Advertenties
Inhoudsopgave
