Inhoudsopgave
Advertenties
SECTION 7
"," -
"''C~''
' "
"
\~-.,
,A,
,
,
Fig. 7-8 D-Series Lift Linkage
Hole
Attachment
A
Snow Thrower
B
Mower
Grader Blade
C
Dozer Blade
D
Float Lockout Pin
(Grader Blade)
To lock out the float feature, insert the 1/2 x 2 clevis
pin supplied with the grader blade through the two
holes of the lift arms and the hole in the float arm.
Secure the pin with the large hairpin cotter. Never
use the mower or snowthrower with pin installed.
Remove Hydraulic Lift Mechanism
Refer to Fig. 7-8 during the following
procedure.
1. Remove access cover plate in front of seat.
2. Remove cotter pin and clevis pin from cylinder rod.
3_ Remove four (4) bolts from bellcrank pivot bearings.
4. Lower bellcrank assembly through bottom of frame.
Remove Hydraulic Cylinder
1. Remove access cover plate in front of seat.
2. Disconnect hoses from front and rear of cylinder. Note
connections for reinstallation. See Fig. 7-9.
7-4
'"
Fig. 7-9 D-Series Hydraulic Hose Routing
3. Remove cotter pin and clevis pin from cylinder rod
separating bellcrank from cylinder.
4. Remove snap ring from left side of rear pivot pin and
slide pin to the
right.
5. Remove hydraulic cylinder.
After reassembling, check transaxle oil level after running
the engine and operating the lift system for one (1) minute.
Remove Hydraulic Valve
Fig. 7-10 D-Series Hydraulic System
Advertenties
Inhoudsopgave
