Inhoudsopgave
Advertenties
SECTION 6
Seat Switch
A seat switch is incorporated on C-Series
tractors.
If the
driver rises off his seat with the PTO engaged, the seat
switch interrupts the ignition coil voltage and the engine
stops. The seat switch has no effect on the tractor unless
the PTO lever is
engaged~
The engine can be started without the seat switch being
depressed.
Fig. 6-10 C-Series Seat Switch
The seat switch is located under the seat in the seat pan.
See Fig. 6-10. To replace the switch, remove the transaxle
oil dip stick for finger access to the switch. Remove the
nut from the top of the switch and pull the switch from the
seat pan.
Lighting Circuit
The light circuit on C-Series tractors (optional on some
models) is powered by the battery.
The lights operate
when the ignition switch is in the Run position. A 20 amp
SFE fuse is part of the light circuit. The fuse is contained in
a fuse capsule connected between the ignition switch and
the light switch, behind the dash panel.
Wiring Harness
Harness routing for the C-Series is shown in
Fig.
6-11 a
and Fig. 6-11 b. Refer to C-Series electrical circuit diagram
for connections when servicing or replacing the entire har-
ness. See Fig. 6-13.
6-4
.
...
...
..:::..:.,
~"'""
L
. .
-.
~~.,
....
-:y
.,.
..
.:..~
..
"'"""
..
__
.'
.....
~
.
~:. ~{;;~~~;
Fig. 6-11 a C-Series Harness Routing (All but C-81)
Fig.6-11b C-Series Harness Routing (C-81 Only)
Fig. 6-12 C-Series Harness Routing
Advertenties
Inhoudsopgave
