Advertenties
7. INSTALLATION
7.1 Inspections on arrival
7.1.1
All machines are packed in cardboard boxes specific for each unit.
ing it are written on the packing.
The storage temperature must be between -25°C and 55°C.
WARNING
cycled waste.
material as it may be a potential source of danger.
Once the place in which the unit is to be installed has been chosen (see the rela-
tive sections) proceed as follows to unpack the indoor unit.
Installation requirements
• The indoor unit is packed in a box.
•
• Check if all indoor unit accessories are enclosed.
• Bring the unit as close as possible to the final installation position in its original
package in order to prevent damage during transport.
7.1.2 Selecting the installation site and minimum operating area for indoor unit
WARNING
There is flammable refrigerant in the unit and it should be installed in a well-ventilated site. Be sure to adopt ade-
quate measures to prevent the unit from being used as a shelter by small animals.
The equipment is not intended for use in a potentially explosive atmosphere.
•
- Places that are well-ventilated.
- Safe places which can bear the unit's weight and vibration.
- Places where servicing space can be well ensured.
- Places where the units' piping and wiring lengths come within the allowable ranges.
- Places where water leaking from the unit cannot cause damage to the location.
- Do not install the unit in places often used as a work space. In case of construction work (e.g. grinding etc.) where a lot of
dust is created, the unit must be covered.
- Do not climb, sit or stand on top of the unit.
- Be sure that sufficient precautions are taken in case of refrigerant leakage according to relevant local laws and regulations.
The place of installation must be free of powders, flammable objects or materials or corrosive gases.
EN
90
-
-
-
Cod. 354M000010 - Rev. 03 - 06/2023
OMNIA SW-T 3.2
fig. 8 -
-
Advertenties
