Advertenties
OMNIA SW-T 3.2
8.5.1 Heat / Cool operating mode selection (Operation Mode)
Menù Hp > Operation mode > select the mode and confirm with the button
8.5.2 Daily schedule / climatic curves / Eco mode (Preset Temp)
Menù Hp > Preset temp >
This function acts only on single zone, and if 2 zones are enabled only on zone 1: therefore it has no effect on zone2.
If the unit is in Cool mode, the events to be considered are those in the "Preset Temp. Cool" menu, while if the machine is in Heat mode the events to be considered
are those in the "Preset Temp. Heat" menu.
The current default temperature is invalid when the unit is turned off (OFF).
The unit will operate at the default temperature of the first event following the activation time of the unit itself.
Menù Hp > Preset temp > Preset Temp Cool
Event 1
Event 2
Time
Event 3
Temperature
Event 4
Event 5
Event 6
Menù Hp > Preset temp > Preset Temp Heat
Event 1
Event 2
Time
Event 3
Temperature
Event 4
Event 5
Event 6
The temperature setting remains active until the next enabled event. At the start of this new enabled event, the new associated temperature is set on the machine
and so on.
Climatic curves (Climatic Temp)
Menù Hp > Preset temp > Weather Temp Set
Z1 Cool Mode
Clim Curve Sel
Z1 Heat Mode
Clim Curve Sel
Enabled
Z2 Cool Mode
Clim Curve Sel
Z2 Heat Mode
Clim Curve Sel
Modalità Economy (Eco Mode)
Menù Hp > Preset temp > Eco Mode
Clim Curve Sel
1-9
Start
hh.mm
End
hh.mm
If ECO mode is enabled:
•
Timer = enabled, the start and end times must be set
Enables the Eevent
Start time hh.mm
Water temperature setpoint
Enables the Eevent
Start time hh.mm
Water temperature setpoint
Enables climatic curve for zone 1 in cooling mode
to select the climatic curve in cooling mode
Enables climatic curve for zone 1 in heating mode
to select the climatic curve in heating mode
to select the climatic curve in cooling mode
to select the climatic curve in heating mode
Enables climatic curve for zone 2 in heating mode
to select the climatic curve in heating mode
enables ECO function (not availbale for 2 zones)
select the climatic curve from 1 to 9
Enables the timer
start time
end time
Cod. 354M000010 - Rev. 03 - 06/2023
EN
113
Advertenties
