Advertenties
OMNIA SW-T 3.2
CAUTION
Ground the unit.
Grounding resistance should be according to local laws and regulations.
Do not connect the ground wire to gas or water pipes, lightning conductors or telephone ground wires.
Water pipes: Hard vinyl tubes are not effective grounds.
bolt.
Install the power wire at least 1 meter away from televisions or radios to prevent interference or noise.
(Depending on the radio waves, a distance of 1 meter may not be sufficient to eliminate the noise.)
national wiring regulations. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
Do not install the unit in the following places:
•
Where there is mist of mineral oil, oil spray or vapors. Plastic parts may deteriorate, and cause them to come
•
Where corrosive gases (such as sulphurous acid gas) are produced. Where corrosion of copper pipes or solde-
•
Where there is machinery which emits electromagnetic waves. Electromagnetic waves can disturb the control
system and cause equipment malfunction.
•
flammables such as paint thinner or gasoline are handled. These types of gases might cause a fire.
•
Where voltage fluctuates a lot, such as in factories.
•
In vehicles or vessels.
•
This appliance can be used by children 8 years old and above and persons with reduced physical, sensory or mental
safe manner and understand the hazards involved. Children should not play with the unit. Cleaning and user main-
tenance should not be done by children without supervision.
Children should be supervised to ensure that they do not play with the appliance.
DISPOSAL: Do not dispose this product as unsorted municipal waste. Collection of such waste separately for
special treatment is necessary. Do not dispose of electrical appliances as municipal waste, use separate collection
facilities. Contact your local government for information regarding the collection systems available. If electrical ap-
food chain, damaging your health and well-being.
The wiring must be performed by professional technicians in accordance with national wiring regulation and this
circuit diagram. An all-pole disconnection device which has at least 3mm separation distance in all pole and a resi-
dual current device(RCD) with the rating not exceeding 30mA shall be incorporated in the fixed wiring according to
the national rule.
Confirm the safety of the installation area (walls, floors, etc. ) without hidden dangers such as water, electricity, and
gas. Before wiring/pipes.
ments of the product are not met, the installation of the product is prohibited until the product is rectified.
When installing multiple air conditioners in a centralized manner, please confirm the load balance of the three-phase
power supply, and multiple units are prevented from being assembled into the same phase of the three-phase power
supply.
Cod. 354M000010 - Rev. 03 - 06/2023
-
EN
75
Advertenties
