Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2
Periodic maintenance
DESCRIPTION
Check the electric cables, high & low pressure ho-
ses, couplings and control of the oil level. Check
the wheel bolts/ Ball clutch/plug/lights/brakes/
good tyre pressure of the trailer
• Refreshing pump oil and reduction gearbox oil
• Cleaning water filters
Cleaning water filters
Replacement oil filters and fuel filters (burner /
• Cleaning fuel tank / fuel filter / air filter
• Checking alternator belt
Change the alternator belt
• All following refreshments of pump oil and re-
duction gearbox oil
• Cleaning of the heat exchanger (depending fluid
properties and calcium deposits)
• Replace the bypass valve(s)
• checking engine clamps and radiator hoses
Refreshing engine oil
Extra control/replacement of joints, valves, o-
rings by acknowledged technicians
• Lubricate or oil all sliding or jointed parts of the
overrun device
• Check on possible wear of the wheel brakes/
bearings/brake lining
• Check engine valve clearance
• Replace air filter element / alternator belt
• Checking injection pump & injection nozzle
(pressure)
• Replace engine clamps and radiator hoses
• Replace the coolant of the engine
3
Control of oil level and refreshing pump oil
Check for each use of the machine, the oil with the oil level glass or with the oil
level bar. Oil must stand right with the sign of the oil level glass, if this is not, oil
tops up until the sign. If oil looks milky, consult directly the DiBO technicians.
To refresh oil, work as follows:
• Unbolt the drain plug below the pump.
• Unbolt the tap with the oil level bar.
• Catch all oil in a barge and remove oil like further described in the guide.
• Force up the drain plug there and top up the oil in the breach to the upper
part to on the mark line.
• Force up the tap with the oil level bar there.
• Recommended oil: 1.836.042 (+- 1Ltr, depending the pump).
4
Control of oil level and refreshing reduction gearbox oil
Check for each use of the machine, the oil with the oil level glass. Oil must stand
right with the sign of the oil level glass, if not the case, refill the oil up to the
mark sign. If oil looks milky, consult directly the DiBO technicians.
To refresh oil, work as follows:
• Unbolt the drain plug below the reduction gearbox.
• Catch all oil in a barge and drain the dirty oil in an environmental friendly way.
• Tighten the drain plug (with new seal ring) and top up the oil to the upper part
till the mark line.
• Recommended oil: 1.836.015 (0.35 Ltr).
DiBO 35
motor)
E N
S E R V I C E
PERIOD
After each use
First 50 hours
Every 50 hours
First 50 uur, every next
200 hours
Every 100 hours
Every 500 hours. Yearly.
Every 250 hours,
semi-annually
See enclosed motor
instruction manual (first
50 uur, every next
200 hours)
Every 750 hours
Every 500 hours, yearly
Every 2 years
Advertenties
Hoofdstukken
Inhoudsopgave
