Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
After a failed ignition the burning pot must be empty from the amassed pellets, before
starting the stove up again.
• Too much pellets in the burning pot, or humid pellet, or sooty burning pot make ignition difficult and create
dense white smoke which is harmful to health and can cause explosions on the combustion chamber. It is
therefore necessary not to stand in front of the stove during ignition stage if dense white smoke is present.
If after some months the flame appears weak and/or orange colored or the glass tends
to blackens and the burning pot to become encrusted, clean the stove, clean the fume
conduit and the chimney flue.
10.7
POWER FAILURE
• After a black-out, after its reactivation, the stove signals on the display "ALAR NO RETE".
• The stove starts the switching off phase up by activating the fume fan which for 15 minutes will arrange for the
fume remainings expulsion.
• Reset the error with P4 key.
• Clean the burning pot and start the stove up again with P4 key.
10.8
TEMPERATURE SETTING
• To modify the ambient temperature it is sufficient to keep pressed P3 key and at the same time select the
temperature with P1 and P2 keys.
• The selected temperature and the ambient temperature are shown on the Display B.
• If the ambient temperature value exceeds the selected limit, the calorific power falls at the minimum till the
threshold return at the preset value, then the display shows "RIS".
10.9
FUME TEMPERATURE
To check fume temperature at the exhaust outlet, it is sufficient to keep pressed P1 key.
10.10
SWITCHING OFF
To switch the stove off, keep pressed P4 key: the display A shows "OFF". After about 15-20 minutes also the fume
fan switches off (this occurs always wheter the stove is hot or cold).
If the pellets are of bad quality (if contains sizing agents, oils, varnishes, plastic remains or if
it is mealy), deposits will form along pellets drop pipe during the running. When the stove is
switched off, these remains could form little hot coals that rising along the pipe could reach
the pellets on the hopper burning them and creating a thick and harmful smoke inside the
room. Please always keep the hopper closed with its own lid. If the pipe is sooty, please
clean it (see INTRODUCTION page 22).
10.11
CLOCK SETTING
• Press many times P3 key till the green led with the clock appears.
• Then the display shows "UT02": adjust the time with P1 and P2 keys.
10.12
WEEKLY SETTING
It is possible to set the ignition and the switching off of the stove daily for 7 days and with 2 daily intervals
(PROGRAM 1 and PROGRAM 2).
In every moment, P4 key enables to exit from the programming.
The chronothermostat parameters are the following:
DISPLAY
UT01
UT02
UT03
FAMILY
SETTING
Current day and use mode
Time
Minutes
EN
19
Advertenties
Hoofdstukken
Inhoudsopgave
