Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Opening the steam generator
To open the steam generator (Figure 2):
1. Loosen the 4 screws on the front.
2. Carefully lift the front cover slightly.
3. Pull the front cover straight out.
1
3
1
Figure 2 Opening the steam generator
Positioning the steam generator
Installation must be carried out by an authorised electrician and
authorised plumber. The steam generator must be connected with
a fixed connection. It is installed outside the steamroom but as
close to it as possible. The maximum length of the steam pipe is
15 metres.
Lock the steam generator into place with the lock screw, see
Figures 6,7.
Take care to respect the specified installation distances (Figures
3, 4). The distances indicated are generous to allow sufficient
space for maintenance and servicing.
The steam generator is to be located in a dry and ventilated
space with drainage, above, below or on the same level as
the steamroom (never in an aggressive environment that can
cause corrosion/rust). The steam generator may not be installed
outdoors. The maximum difference in height between the steam
generator and the steamroom is 3 metres. (Figure 5)
The steam generator The steam generator must be installed hori-
zontally, at such a height above the floor so that the drainage pipe
will have a good fall to its drain.
The wall material must support the steam generator's total weight
during installation.
Weight of steam generator incl. water:
Steam Home - 16 kg
Steam Commercial - 29 kg
2
2
1
1
min.
500mm
min.
300mm
min.
700mm
Figure 3 Suspending the steam generator
min.
300mm
min. 50mm
Figure 4 Minimum dimensions for positioning steam generator
inside a ventilated cabinet
min. 350mm
min. 565mm
min. 350mm
min. 985mm Home
min. 1050mm Commercial
min.
300mm
min.
300mm
35
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
