Advertenties
Beschikbare talen
Beschikbare talen
GB
ENGLISH
2.2 - Horizontal Configuration
Screw the 4 rubber feet supplied loose in the package into the brass seats in face E. Put
the system in place, taking into account the dimensions in Fig.8.
• The distance of at least 10mm between Face B of the system and an obstruction is
obligatory to let out the power supply cable to the mains socket.
• The distance of at least 200mm between Face A of the system and an obstruction is
recommended so as to be able to remove the door and gain access to the technical
compartment.
If the surface is not flat, unscrew the foot that is not touching and adjust its height until it
contacts the surface so as to ensure the stability of the system. The system must in fact
be placed in a safe and stable position, ensuring that its axis is vertical: it must not be in
an inclined position.
2.2.1 Hydraulic connections
Make the connection at input to the system through the mouth on Face C marked "IN" in Fig. 8
(suction connection). Then remove the cap using a screwdriver. Make the connection at output
from the system through the mouth on Face C marked "OUT 1" in Fig. 8 and/or through the mouth
on Face F marked "OUT 2" in Fig. 8 (delivery connection).
In this configuration either of the 2 mouths can be used as an alternative to the other (depending
45
on the convenience of the installation), or simultaneously (dual delivery system). Then remove
the cap(s) from the door(s) you intend to use with a screwdriver.
All the hydraulic connections of the system to the plant to which it can be connected are of the
threaded female type 1" GAS, made of brass.
See WARNING for Figure 7.
Figure 8
2.2.2 Orientation of the Interface Panel
The Interface Panel has been designed so that it can be oriented in the direction where it
is most convenient for the user to read: its square shape allows it to be rotated from 90°
to 90° (Fig.9).
Figure 9
Advertenties
