Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Should it become necessary to switch to a
preservation cycle associated to a different
program, you must enable the corresponding
program priorly, by pressing the button (11).
Once you have enabled the program, switch to
the preservation cycle by pressing buttons (2)
and (1) simultaneously for 3 seconds. The
machine will enable the preservation cycles
associated to the preset program.
SWITCHING FROM PRESERVATION PHASE
TO A PRODUCTION PROGRAM
With the preservation active, you can activate an
automatic program simply by selecting it by
pressing button (11). The LED corresponding to
the selected program will flash for 3 seconds
and become steadily lit; the machine will exit the
preservation cycle and run the selected
program.
Subsequently, the preservation cycles
associated to the selected program ill be
enabled.
PADDLE LOCK UPON LID OPENING
The opening of the lid (3) only stops the paddle
(5) and does not affect the preservation cycle.
The closure of the lid (3) enables the paddle
operation (5) (on the condition that it is provided
by the selected preservation cycle in that
moment). If the mixture proves excessively hard
and prevents the movement of the paddle, the
machine will automatically re-activate the
preservation cycle from the start.
TURNING OFF THE MACHINE DURING
PRESERVATION
To turn off the machine, hold down button (11)
for 3 seconds and then act on the main switch
(10). Do not act directly on the main switch (10)!
IMPORTANT
•Each preservation cycle continues until the
user decides to stop it.
•The machine is not designed for use either for
storage or as a refrigerator! Store the
preparation in the pot for no longer than 12
hours.
•The cooling fan of the cooling system will
always remain in operation for the entire
duration of the preservation period.
•After use, ALWAYS turn the machine off using
the main switch (10).
TIPS
•Using ingredients at refrigerator temperature
English
will reduce the processing time. Furthermore,
it is possible to reduce the temperature of the
ingredients if hot with the appropriate fast
cooling program.
•Be careful not to insert ingredients that are too
cold or nearly froze, as whipping may have a
poor quality.
•For a correct volume increase during mixing,
use maximum 1.25kg of ingredients for the
preparation of ice cream and sorbet.
•For the preparation of Granita, the maximum
amount of ingredients is 1Kg with the paddle
supplied with the machine.
It can process up to 1.5kg of Granita using the
special Granita paddle that can be purchased
separately.
CLEANING THE POT
GELATO 5Ksc CREA is designed to facilitate
pot cleaning. Proceed as follows:
•Turn off the cooling system, remove the paddle
and pour at least 2 litres of hot water and a low-
foaming detergent into the pot.
•Wash the pot with a sponge. Do not use sharp
utensils inside the pot.
•Place an empty container of at least 3 litres
under the drain (8).
•Remove the plug (9). The water in the pot
begins to flow into the container below.
•Repeat the operation using hot, clean water
and rinse thoroughly.
•When the pot is empty, clean the discharge
pipe using the cleaner (14) previously
cleaned.
•Reposition the plug (9) until the pot discharge
is fully closed.
•If necessary, repeat the cycle until the pot is
completely cleaned. Proceed with the
sanitization (see the SANITIZATION chapter)
in order to avoid any bacteria growth.
•Dry with a disposable paper towel.
MAINTENANCE AND CLEANING OF THE
MACHINE
•Before cleaning the machine, make sure that it
is turned off (main switch (10) to OFF) and
unplugged from the power plug.
•Remove the paddle scrapers (18) and (19) by
pulling outwards.
•Remove the steel pin and remove the
transparent lid (3) from the machine.
9
Advertenties
Inhoudsopgave
