Inhoudsopgave
Advertenties
For Smart Use of The Air Conditioner
Setting of proper room
temperature.
Proper
temperature
Close doors and windows
during operation.
EN
During cooling
operation prevent
the penetration of
direct sunlight with
curtain or blind.
If the unit is not to be used
for a long time, turn off the
power supply main switch.
OFF
Before asking for service, check the following first.
Phenomenon
The system
does not restart
immediately.
Noise is heard
Normal
Perform-
ance
inspection
Smells are
generated.
Mist or steam are
blown out.
13
Maintenance
Do not block the air inlet or
outlet.
Use the timer effectively.
Use the louvers effectively
Trouble shooting
Cause or check points
●When unit is stopped, it won't restart
immediately until 3 minutes have elapsed
to protect the system.
●When the electric plug is pulled out and
reinserted, the protection circuit will work
for 3 minutes to protect the air conditioner.
●During unit operation or at stop, a
swishing or gurgling noise may be heard.
At first 2-3 minutes after unit start, this
noise is more noticeable. (This noise is
generated by refrigerant flowing in the
system.)
●During unit operation, a cracking noise
may be heard. This noise is generated
by the casing expanding or shrinking
because of temperature changes.
●Should there be a big noise from air flow
in unit operation, air filter may be too dirty.
●This is because the system circulates
smells from the interior air such as the
smell of furniture, paint, cigarettes.
●During COOL or DRY operation, indoor
unit may blow out mist. This is due to the
sudden cooling of indoor air.
Remote Controller
Indoor Body
Do not use water, wipe
wipe the air conditioner by using
a soft and dry cloth. For serious
the controller
with a dry cloth.
stains, use a neutral detergent
diluted with water. Wring the
Do not use
water out of the cloth before wiping, then wipe off the
glass cleaner or
detergent completely.
chemical cloth.
Do not use the following for cleaning
Do not use any chemicals or chemically treated
cloths to clean the unit
Do not use benzene, paint thinner, polishing powder
or other solvents to clean the unit. They can cause the
plastic surface to crack or deform.
Air Filter cleaning
1.Open the inlet grille by pulling it upward.
2.Remove the filter.
Push up the filter's center tab slightly until it is
released from the stopper, and remove the filter downward.
3.Clean the filter.
Use a vacuum cleaner to remove dust, or wash the filter with water. After washing,
dry the filter completely in the shade.
4.Attach the filter.
Attach the filter correctly so that the "FRONT" indication
is facing to the front. Make sure that the filter is
completely fixed behind the stopper. If the right and
left filters are not attached correctly, that may cause
defects.
5.Close the inlet grille.
Phenomenon
In dry mode,fan
speed can't be
Normal
changed.
Perform-
ance
inspection
Poor cooling
Multiple
check
Hot water over 40 °C (104
°F) may cause discoloring
or deformation.
Once every
two weeks
Cause or check points
●In DRY mode, when room temperature
becomes lower than temp.setting + 2 °C,
unit will run intermittently at LOW speed
regardless of FAN setting.
●Is power plug inserted?
●Is there a power failure?
●Is fuse blownout?
●Is the air filter dirty?
Normally it should be cleaned every 15
days.
●Are there any obstacles before inlet and
outlet?
●Is temperature set correctly?
●Are there some doors or windows left
open?
●Is there any direct sunlight through the
window during the cooling operation? (Use
curtain)
●Are there too much heat sources or too
many people in the room during cooling
operation?
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
Gerelateerde Producten voor Hansgrohe AS25PCHHRA-NR
- Hansgrohe Raindance Classic AIR 27424 Series
- Hansgrohe Raindance Classic AIR 27428 Series
- Hansgrohe Raindance Classic AIR 27430 Series
- Hansgrohe Raindance Classic AIR 27400 Series
- Hansgrohe Raindance Classic AIR 27406 Series
- Hansgrohe AXOR 42604 Series
- Hansgrohe AXOR 42605 Series
- Hansgrohe AXOR 42610 Series