Indoor Unit Installation - Hansgrohe AS25PCHHRA-NR Handleiding

Inhoudsopgave

Advertenties

Necessary Tools for Installation

●Driver

●Nipper

●Hacksaw

●Hole core drill

●Spanner(17,19 and 26mm)

●Gas leakage detector or

soap-and-water solution

Selection of Installation Place

●Place, robust not causing vibration, where the body can be

supported sufÏciently.

●Place, not affected by heat or steam generated in the vicinity,

where inlet and outlet of the unit are not disturbed.

●Place, possible to drain easily, where piping can be connected

with the outdoor unit.

●Place, where cold air can be spread in a room entirely.

●Place, nearby a power receptacle, with enough space around.

●Place where the distance of more than 1m from televisions,

radios, wireless apparatuses and fluorescent lamps can be left.

●In the case of fixing the remote controller on a wall, place where

the indoor unit can receive signals when the fluorescent lamps in

the room are lightened.

The models adopt HFC refrigerant R32.

more than 15 cm

more than

10cm

The distance between the indoor unit and the floor should be more than 2m.

Please be subject to the actual product purchased, the above picture is just for your reference.

If using the left side drain pipe, make sure the hole is got through.