Advertenties
Beschikbare talen
Beschikbare talen
DANGEROUS MISUSE
➢ Do not use the product unless it has been correctly installed in accordance with the regulations in force, with
the appropriate safety devices for the type of installation.
➢ do not use the product in the event of a power supply fault or in the event of serious maintenance deficiencies
or after modifications or interventions;
➢ do not use the product to charge batteries other than those permitted;
➢ do not stack multiple chargers or cover the charger during use and charging;
➢ do not use the product outdoors or in other than permitted environmental conditions;
➢ do not use the product in the rain or in damp and/or outdoor environments;
➢ do not operate the charger in an environment that is fully or partially classified as a fire or explosion hazard;
➢ it is forbidden to use the charger as a base for objects of any kind, and it is also forbidden to have containers
with liquids near the charger;
➢ do not cover the charger or place objects on it;
➢ do not set the charger on the battery;
➢ do not alter or open the charger;
➢ do not insert objects into the slots of the charger;
➢ do not connect the charger's electrical contacts with metal objects or short-circuit them.
➢ ensure that there are no sparks or sources of ignition near the battery; during charging, batteries can emit
explosive gases;
➢ do not use the product in violation of regulatory and/or legislative requirements or those set out in this manual.
4.
SAFETY
4.1 GENERAL INFORMATION
It is the customer's responsibility to instruct personnel in charge of the use of the product on the risks of accidents,
safety devices and the general rules on accident prevention laid down by EU directives and the legislation of the
country where the product is used.
The personnel in charge must be familiar with the characteristics of the product.
They must also have read this manual and all the manuals mentioned in Chapter 10 (Annexes) in full.
Installation and maintenance work must be carried out by qualified personnel.
DANGER
Unauthorised tampering with or replacement of one or more parts of the product, the adoption of accessories that
change the use of the product, and the use of spare parts other than those recommended may become a cause
of risk of injury.
The installation and maintenance of the product must only be carried out by instructed and duly qualified personnel,
with the electrical, mechanical and pneumatic technical knowledge and any requirements valid at the site or in the
country where the product is used.
4.2 APPLIED DIRECTIVES AND TECHNICAL STANDARDS
Every product destined for countries within the European Union (EU), or countries for which there is an agreement
with the EU regarding product legislation, is supplied with a Declaration of Conformity in accordance with the
Machinery Directive 2006/42/EC.
As the machine is covered by Annex IV, the manufacturer applies the examination procedure for EC type-
examination as set out in Annex IX, plus internal checks on the manufacture of the product as set out in Annex VIII
of Directive 2006/42/EC.
0310.0353_04
79
Advertenties
