Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
8. Assembly/Disassembly
Test all functions
1. Check all Handset button and for FloorLine-i
Plus the ACK buttons are working to the full
travel range of adjustment for each position
(Backrest, Kneebreak, Hi-Lo, Trendelenburg/
Rev, Auto Contour, CPR).
2. Confirm mechanical working order of the CPR
Emergency quick release level. (FloorLine
i-Plus)
3. Confirm working order of all other attached
accessories.
9. Operation Instructions
9.1 Before putting this bed into service for
the first time
1. Read through this Instruction Manual
completely, understanding all operations and
functions, (Operating The Bed). Pay special
attention to all safety issues, so as to prevent
injury to persons, or damage to the bed or
environment, due to incorrect operation.
2. Confirm that the electricity supply and
the wall power-point/outlet/socket are
both compatible with the bed's voltage
requirements and the bed's mains supply
cable plug. This will differ between countries.
3. Inspect the mains supply cable for perfect
condition. Check for any damage in transit..
4. Fully unpack and assemble the bed and attach
all accessories.
5. Confirm that all cables and cords (eg mains-
power supply cable, motor cables and
handset cable) are connected and securely
routed out of the way of all the bed's moving
parts, so they can not be damaged. Also
confirm that there are no obstacles, (eg
bedside cabinets, chairs, or wall fixtures, etc.)
which could impede adjustment of the bed.
22
Battery back up (FloorLine-i Plus)
The Backup Battery will take approx. 12 hours to
fully charge. While charging, the ACK indicator
light will flash yellow/orange. To ensure long
battery life, the bed should be connected to
mains power at all possible times.
Disassembly
Do the assembly instruction in reverse.
6. Confirm that all nuts, locking bolts, pins and
fasteners are fully engaged and correctly
tightened. Ensure that the battery is plugged
into the control unit. Regular checks are
recommended (see the Checklist).
7. For safety, ensure that all bed wheel castors
are locked unless the bed is being moved.
8. Test that the bed and all its accessories
(including all adjustment functions) are all
fully functioning and in perfect working order.
9. Clean and disinfect the bed prior to placing
the mattress and any bedding on the bed, for
first time use.
9.2 Putting the bed into service
1. Read and follow the previous section,
including reading this Instruction Manual,
and attending to all safety issues & operation
usage.
2. Confirm wheel castors are locked.
3. Ensure clearance for bed movements.
ENG
ENG
www.humancaregroup.com
Advertenties
Inhoudsopgave
