Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
7. Safety Advice
In this way, you greatly reduce the risk of
patient injury as a result of falling out of bed.
• If a patients' condition contains a risk of
entrapment, then the mattress platform
should always be left in a flat position.
• Take care with the use of side rails. If the
side rails are raised, there is a risk of limbs
gettng trapped or crushed on adjusting the
8. Assembly/Disassembly
8.1 General information
Requirements
1. Two qualified assembly persons who are very
familiar with this User Manual and all facets
of bed assembly and operation.
2. A mains power outlet/power-point since the
Backup Battery may not be fully charged at
time of delivery.
Tools Required
1. 3mm & 5mm Allen Keys
2. 13mm & 17mm spanner/socket wrench
Delivery
The bed is delivered, packed in two cartons:
1. Folded Bed Base, Attached Handset, Head/
Foot Boards
2. Folded Mattress Platform
Bed assembly stages
1) Pre Assembly
2) Bed Base Assembly
3) Raise The Bed Base
4) Mattress Platform Assembly
5) Attach Mattress Platform to the Bed Base
6) Connecting Cables & Mattress Retainers
7) Conclude Assembly & Test all Functions.
www.humancaregroup.com
backrest or kneebreak. Human Care strongly
recommends against the use of side rails.
7.6 Checks and inspections
Make sure to follow mainteance instructions to
ensure safe use ot the bed..
Pre-assembly
1. Confirm power source is compatible.
2. Ensure there is floor space for assembly.
3. Assemble on a covered surface, to protect
both floor and bed surfaces. The packing
cardboard is a useful protector.
4. Remove all packaging materials and transport-
securing devices from Bed Base box only.
(Leave Mattress Platform box until later).
5. The unpacked folded bed base will be resting
upright on all four wheel castors.
8.3 Assembly instruction
Bed base assembly
Starting position before assembly:
Resting upright, the lower saddle is positioned
on top. The two bed base lower beams are
hinged in half at the saddle and are positioned
perpendicular to the floor.
Position after assembly:
The lower beams must be flattened and
pedestal ends vertical and secured with bolts.
1. Ensure all castors are locked for safety.
2. Separate out the cables (3 including Handset)
and gently fold them, out of the way, over the
head pedestal end.
ENG
ENG
17
Advertenties
Inhoudsopgave
