Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6. Optional Accessories
8. Ensure all castors are locked for safety.
9. Using the handset, flatten/neutralize all
the bed positions (backrest, kneebreak,
Trendelenburg/reverse).
Disconnect cables
1. To allow better access to cables and bolts:
• Raise the bed to its maximum height and
• Lift backrest and foot-end panels.
2. Release the backrest and kneebreak cables
from the plastic retaining clips (1 backrest
cable clip/3 kneebreak cable clips) that secure
them to inside of the mattress platform
frame.
3. Disconnect the kneebreak (long) cable from
its mini-fit actuator plug, by first removing
the plastic retaining clip with a small flat
screwdriver.
4. Set aside the plastic retaining clips and keep
the cable safe.
5. Repeat above step for backrest (short) cable.
6.2 Fitting the Extension Kit
The lower beam has a built in adjustment, to
allow the Extension Kit to be fitted to the top
beam of the mattress platform.
1. Confirm all the kit contents.
2. Remove the Head & Foot Boards.
3. Release the Backrest & Kneebreak cables from
the actuators, by removing the plastic circlip
in the connector.
4. Loosen the mattress platform locking bolts
with an electric drill (Pic 1).
5. Swing the link brackets away at the head end,
then lower the mattress platform onto the
lower beams at head end (Pic 2).
6. Using two people, remove the mattress
platform and carefully place it on a work
bench or table (Pic 3).
7. Remove the 2 circlips at the foot end of the
lower beam saddle, of the bed base, then
remove all 4 pins (Pic 4).
14
8. Extend the lower beams and replace the 4
pins in the outermost holes, then replace the
circlips (Pic 5).
9. Remove the 2 circlips on the head end of the
lower beam saddle and then remove all 4 pins
(The lower beams are now extended) (Pic 6).
10. Remove the mattress platform locking bolts
and fit them to the extension brackets (Pic 7).
11. Remove the mattress platform standard
brackets, at the foot end and replace them
with the extension brackets. Note that the
support tab sits under platform (Pic 8).
12. Fit the extension panel with the button head
screws and Nyloc nuts (Pic 9).
13. Using 2 people, replace the extended
mattress platform, foot end first, ensuring
that the nylon bushes are in the hooks - Do
not over tighten locking bolts (Pic 10).
14. Replace the backrest and kneebreak cables
into the actuator connectors.
15. The Mattress and Bolster can now be placed
on bed (Pic 11).
16. Check all bed functions.
NOTE: The standard length beam brackets
should be kept, so that the bed can be
returned to it's standard length.
ENG
www.humancaregroup.com
Advertenties
Inhoudsopgave
