Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
8. Assembly/Disassembly
Using the junction box (FloorLine-i Plus)
1. Plug the cable with the least amount of coils
and the modular plug with coloured wires
that comes out of the HB port of the control
box into any port of the spare Junction Box.
2. Remove the handset from the mattress
platform. (Take note of which port that you
removed it from so that you can replace it
afterwards) or use an spare handset.
3. Plug the handset into any port of the Junction
Box.
4. The bed can now be raised, using the
handset, now connected to the Control Box
via the Junction Box.
Do not lower the bed with the
o
handset control at this stage, or
damage may occur!
Raise the bed
1. Plug the mains power cord into the wall
outlet/socket/power point.
2. Using the Handset, (already secured to the
bed base and attached to the control box),
raise the bed base 300mm (12"), to aid
Mattress Platform attachment to Bed Base.
DO NOT LOWER THE BED AT THIS STAGE!
DAMAGE TO CHAINS MAY OCCUR!
Mattress platform assembly
1. Lay mattress platform box flat on the floor.
2. Open the 3 taped sides and fold out the
cardboard box to cover the floor for assembly.
As the mattress platform is assembled,
remove all packaging materials and transport-
securing devices.
3. Remove the two locking lanyard pins from
either side of the centre hinge section/upper
beam saddle.
Folded Mattress Platform
Upper Beam Saddle
Locking Lanyard Pin
www.humancaregroup.com
4. Unlatch the metal transport latch.
5. Unfold the mattress platform until the beams
are straight. The flat mattress side will be
facing down on the cardboard.
6. Re-insert the 2 locking lanyard pins, to lock
the mattress platform into a flat position.
NOTE: The pins may be a tight fit. Gently
lifting one side aids fitting each pin in.
NOTE: The mattress platform has a small
centred positive camber; deliberately
designed to support the integral strength
of the bed. After initial loading and use
the camber will decrease slightly.
Attach the mattress platform to the bed base
1. With both persons on one side, vertically raise
the mattress platform to its side with the
beams facing away from the body.
2. One person then brings the bed base
(unlocking the castors, first), to the platform.
Ensure that the base head end aligns with the
platform head end and the platform beams
are facing the base. Relock the castors.
3. Both persons should carefully lift the mattress
platform to lie flat on the base.
ENSURE:
1) The backrest panel (largest panel) is
positioned at the head end of the bed base
(near the green wheel castor).
2) Beams face down, and panels are up.
3) Both platform upper beams sit over and
outside the base lower beams.
Note: Keep the cables and actuators safe
that are located inside the bottom of the
mattress platform.
ENG
19
Advertenties
Inhoudsopgave
