Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
8. Assembly/Disassembly
2. Connect up all cables as per the Electrical
Cable Connection Chart (see below). Where
necessary, secure all cords/cables to the bed
frame with the plastic clips.
3. Attach the mains cable to the mains power
supply, re-checking for possible transit
damage.
The Hi-Lo Actuators are attached to the Foot
End and to the Head End.
The Hi-Lo Actuator Cables are secured to the
inside of the lower beam with a 'P' Clip.
Electrical cable connection chart (FloorLine-i Plus)
FROM
Backrest Actuator
Head End Lift Actuator
Kneebreak Actuator
Foot End Lift Actuator
Under Bed Light Junction
# 1.
Under Bed Light # 1, Port 1.
Under Bed Light # 2, Port 1.
Handset
Port Plugs
Note: Under Bed Light #2 is on the same side as
the directional or green castor.
Unlock factory-default setting (FloorLine-i Plus)
All functions are locked as a pre-set factory
default. The functions must be unlocked with
the Lockout Button on the ACK. To unlock each
www.humancaregroup.com
TO
Control Box Port 1.
Control Box Port 2.
Control Box Port 3.
Control Box Port 4.
Control Box Port HB
Under Bed Light # 2, Port 5.
Attendant Control Panel
Under Bed Light # 2, Port
2 or 4.
Empty Ports
function it is necessary to hold the 'Lockout'
Button simultaneously with each function
button, one at a time. Each function button's
LED light will stop illuminating, when the
function has been unlocked. (This is a toggled
action, so repeating this process will lock a
function and illuminate the LED light for that
function).
Handset control initialisation (FloorLine-i Plus)
Initialisation sets the system up for the initial/
base position, for the electric actuators.
1. All functions are initialised by pressing the 'HI-
LO UP' and 'HI-LO DOWN' buttons EXACTLY
AND SIMULTANEOUSLY on the Backlit Handset
Control. An intermittent beep will begin. Keep
pressing the buttons until the beep stops.
2. Initialise the HI-LO actuators by pressing
the 'HI-LO DOWN' button until the mattress
platform is at the bed's lowest height. Hold
the button for approx. 1 second after the
actuators have stopped. Both actuators are
now set to be at their lowest position. The
Backrest and Kneebreak actuators do not
employ any positional feedback, and do not
require initialisation.
3. Confirm that the lowest position of the
mattress platform is perfectly horizontal.
Connecting mattress retainers
Using the screws provided, attach the 4 mattress
retainers to the mattress platform.
Concluding assembly
1. Add any ordered accessories such as Self Help
Pole, IV Pole, wall bumper, etc.
2. Re-check that all attachments are tightened
3. Lower (identical) Head & Footboards into the
bracket slots on the inside of each pedestal
end (in front of the IV Pole slot).
4. Ensure the bed is fully cleaned before placing
the mattress on the bed.
ENG
21
Advertenties
Inhoudsopgave
