Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
E N
M A L F U N C T I O N TA B L E
MALFUNCTION
Machine does not start
No water pressure
Instable and to weak pressure
No hot water
Ventilator does not turn
HP pump pulse
Hot water temperature is not reached
Insufficient braking of trailer
Overheating of the brakes of trailer
Jerky motion or braking/trailer brakes when
towing vehicle stops accelerating/overrun
device makes noise.
Trailer brakes during reverse travel.
Hand brake too weak to stop trailer moving
backwards.
Damage(s)/corrosion/leaks CNG tank and/or
component(s)
Problems on battery
Malfunction table
At a possible malfunction one can consult the table mentioned below and if you
obtain on this basis no solution, we advise to contact a DiBO- technician and/or
a recognized DiBO- representative.
CAUSE
• Battery insufficient
• No fuel (CNG) in engine
• Key switched off
• Rest malfunctions
• Few water supply
• Filter blocked
• Air in water supply (leaks in water
supply)
• Nozzle or lance blocked or worn-out
• Pressure regulator defect
• Rest malfunctions
• Burner temperature not set
• No CNG inside the tank
• Temperature sensor defective
• Rest of malfunctions
• Fuse defect
• Burner temperature not set
• Engine defective
• Leak or congestion in supply line
• To much air present
• Temperature too low or working
pressure to high
• Excessive friction losses or
corrosion on the drawbar
• Damage caused by impact during
manoeuvring
• Hand brake not released
• Jockey wheel blocking the frame
• Shock absorber defective
• Corrosion and/or lack of wheel
brake lubrication
• Too much air in the transmission
system
• Brake pads worn
• All disturbances
• All disturbances
DiBO 46
SOLUTION
• Recharge and/or replace battery
• Fill the tank with CNG
• Put key switch on
• Consult an expert
• Repair water supply
• Clean/replace filter cartridge
• Put machine completely without
power! Repair leaks in supply
• Clean or replace
• Consult an expert
• Consult an expert
• Set burner temperature
• Fill the tank, consult an expert if
necessary
• Consult an expert
• Consult an expert
• Check fuse(s)
• Set burner temperature
• Consult an expert
• Clean/replace/repair
• De aeration of cleaner
• Higher temperature control +
reduce work pressure
• Remove dirt/corrosion. Remove
transmission system & brake +
check on smooth movement.
• Consult an expert
• Release hand brake
• Release jockey wheel and move
into the correct position
• Replace shock absorber
• Remove dirt & corrosion + lubricate
• Replace worn brake shoes
• Braking system adjusted by an
expert
• Consult an expert
• Consult a recognized CNG expert
IMMEDIATELY
• Consult an expert
Advertenties
Hoofdstukken
Inhoudsopgave
