2
High cleaning temperatures
A cleaning temperature of more than 95°C can only be obtained by reducing
the number l/min produced by the high pressure pump. By reducing the engine
speed setting on the display you reduce the number of l/min. The temperature
shall increase until the maximum set value is reached. If the flow is low, the flow
switch shall put the burner out of use, to prevent that the temperature will
increase to high.
On the left & right side you can check the tank levels (CNG & water).
Below you see the indication of the battery power visualised in percentage.
When the level will decrease below 20%, the display will visualize the level in
red color. Above 20%, the filling level will be displayed in green color.
In addition to the battery power indicator, an icon is visible on the left side from
the battery power indication bar. At the right side from the battery power
indicator is the capacity remaining time visualised from the battery.
Below the temperature indication you can see if the burner is active or not.
If you move the control stick 1x up & 1x down, the burner will turn off.
Temperature indication becomes 0° C. The burner hours are visible on the main
screen if pushed on the clock indication. These burner hours will only be visible
at the moment of pushing the (clock) key.
3
Safety message screen
The screen below is always visible. This screen remains visible as long as no
further action is taken. Move the control lever to the left to make the message
disappear.
4
Settings with control stick
The screen includes a number of possible operating pages as shown on the
next pages (depending selected options) when the control stick is operated.
General: when not operating the control stick during 20 seconds, the control
unit will automatically return to the main screen.
5
Control Screen 1 (Operating Instructions)
In this screen you can choose to check the various operating instructions.
Move the control stick to the left (no) or right (yes) to select.
DiBO 31
E N
AC T I VAT I O N