Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
E N
O P E R AT I O N
Start- up procedure battery:
After complete switch-off via the service disconnect plug:
1. Check that both the red and black 48V cables are connected correctly.
2. Insert the service disconnect plug into the battery.
3. Make sure that the emergency stop contact is not pushed.
4. Switch on the key contact of the machine.
Charging procedure battery:
• Power on the charging system by connecting the 240VAC – 50 hz – 1 phase
AC power supply here. This power supply should be fused at 16 amps.
• The system will now start charging. There are 4 charging phases:
1. Pre-charging or pre-heating stage. This phase takes place only at deep
discharge or low temperatures. A low power charge is then performed.
2. Main charging. In this phase, charging takes place with the maximum
charging current. The charger's cooling fan is audible in this phase.
3. Balancing stage. In this phase the individual battery cells are charged to an
equal voltage. A very low current is then charged.
4. Charging finished. The charging is finalized and the State of Charge will be
calibrated again to 100%.
33 I N J E C TO R ( O P T I O N A L )
The injector is optional in 2 different versions namely: fixed mounted version
and removable version. The fixed version does not have the quick couplings
and is attached directly in the flow line. The removable version has a mixing
valve (1) which is equipped with quick couplings (2) to easily remove the product
injector (see pictures below).
Be aware that you have to uncouple the quick couplings ONLY when
the machine is off and there is no pressure inside the hoses anymore!
If you choose to work with a product, you have to reduce the pressure by
turning the lever (adjusting knob - 3) of the special spray lance.
The mixing valve is necessary to adjust the quantity of desired product.
Adjust the desired quantity of the product experimentally.
• Turn to the right to increase the desired product
• Turn to the left to decrease the desired product
1
2
Before taking into use; check if the product can be used and does not affect
the material of the cleaner. Always read the information on the packaging of the
used product. Check if the necessary personal protective equipment (gloves,
clothing, optical device ...) are used. Observe the instructions of the product
conscientiously!
At any doubt, get in touch with the sales representative
of the product or an acknowledged technician.
DiBO 28
3
Advertenties
Hoofdstukken
Inhoudsopgave
