Maintenance; Replacing The Extension Stopper Rubber; Instruction Manual - For Prosthetists; 6-Bar Hydraulic Knee Joint Nk-6 Symphony - Nabtesco NK-6 Symphony Gebruikshandleiding
6-assige hydraulische knie
Verberg thumbnails
Zie ook voor NK-6 Symphony:
- Gebruikersgids (26 pagina's) ,
- Gebruikshandleiding (38 pagina's) ,
- Gebruikersgids (98 pagina's)
Advertenties
Beschikbare talen
Beschikbare talen
7. Maintenance
The maintenance of the device must be carried out
at least every 2 years.
7-1 Replacing the Extension Stopper
MODE D'EMPLOI – À destination des prothésistes
Genou hydraulique à 6 axes NK-6 Symphony
Genou hydraulique à 6 axes NK-6
INSTRUCTION MANUAL – For Prosthetists
6-Bar Hydraulic Knee Joint NK-6 Symphony
6-Bar Hydraulic Knee NK-6
GEBRAUCHSANWEISUNG – Für Orthopädietechniker
6-gliedriges Hydraulik-Kniegelenk NK-6 Symphony
6-gliedriges Hydraulikknie NK-6
MANUAL DE INSTRUCCIONES – Para técnicos ortopédicos
CAUTION
Rodilla hidráulica de 6 ejes NK-6 Symphonyy
Rodilla hidráulica de 6 ejes NK-6
MANUALE DI ISTRUZIONI – Per protesisti
Articolazione del ginocchio idraulico a 6 assi NK-6 Symphony
Ginocchio idraulico a 6 assi NK-6
Hexagon socket head
machine screw
GEBRUIKSHANDLEIDING – Voor prothesisten
(Apply LOCTITE 243)
6-assige hydraulische knie NK-6 Symphony
6-assige hydraulische knie NK-6
P.23
Rubber
Replace the extension stopper rubber
terminal impact occurs in the swing phase (if
the impact cannot be eliminated by adjusting
the valve (E) on the extension side of the
hydraulic cylinder).
*1 The extension stopper rubber is an
expendable. The rubber may deteriorate
earlier under some use conditions. When
replacing
it,
stopper rubber replacement kit (N-G010).
1.
Remove
the
machine screw (M3) using a 2 mm
hexagonal wrench, and remove the rubber
cover.
2.
Remove the extension stopper rubber. It
can be removed easily if the knee joint is in
the stance-flexion state.
3.
Insert the new extension stopper rubber in
the direction shown in Fig. 19. It can
be inserted easily if the knee joint is in
the stance-flexion state.
Insert the rubber with the front oval
protrusion pointing toward the rear of the
knee joint. If it is fitted in a wrong
direction, it cannot be inserted correctly.
4.
Fit the rubber cover, and tighten the
hexagon socket head machine screw after
applying
an
LOCTITE 243 (or its equivalent) to the
threaded portion of the screw.
[Tightening torque: 1.0 N･m]
5.
Perform the same on the opposite side. (2
places on the right and left sides)
Rubber cover
* Set the line on the rubber horizontally.
Fig. 19 Replacing the Extension Stopper Rubber
81-SS00084E (V.2) - 07/2021
EN – 21
purchase
the
extension
hexagon
socket
appropriate
amount
Extension stopper rubber
when
*1
head
of
FR
1
EN
29
DE
57
ES
85
IT
113
NL
141
49
Advertenties
Hoofdstukken
Probleemoplossen
