36 progress
Problem
The cooking zones do
not operate
The appliance does not
heat up.
The oven lamp does not
operate.
Steam and condensation
collect on the food and in
the appliance.
The display shows
, the appliance does
not heat up and there is
no air circulation.
The display shows the
error code "F...".
If you cannot find a solution to the problem
yourself, contact your dealer or the service
centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
TECHNICAL DATA
Voltage
Frequency
INSTALLATION
Warning! Refer to "Safety information"
chapter.
Possible cause
Refer to the user manual for the hob
The appliance is deactivated.
The clock is not set.
The necessary settings are not set.
The automatic switch-off is on.
The Child lock is on.
The fuse in the fuse box is re-
leased.
The oven lamp is defective.
You left the dish in the appliance
for too long.
Demo mode is on.
or
There is an electronic error.
Activate the appliance.
Set the clock.
Do a check of the settings.
Refer to "Automatic switch-off".
Refer to "Deactivating the Child
Lock".
Do a check of the fuse.
If the fuse is released more than
one time, contact a qualified elec-
trician.
Replace the oven lamp.
Do not let the dishes stay in the
appliance for longer than 15-20
minutes after the cooking is com-
pleted.
Deactivate the appliance. Press
for approximately 2 seconds.
An acoustic signal sounds. Press
and hold the buttons
at the same time until the acoustic
signal sounds and the indicator
goes out.
Write down the error code and
contact the Service Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on
the front frame of the oven cavity.
.........................................
.........................................
.........................................
230/400 V
50 Hz
Building Under
Warning! Only a qualified and
competent person must do the
installation of the appliance. If you do
Remedy
and