SC650 66D 1.27 cl/m
SC650 71D 1.37 cl/m
SC650 85D 1.62 cl/m
SC650 71C 1.37 cl/m
3.
If necessary, stop the machine and turn the squeegee adjusting handwheel (27) so that the rear blade (25) - in all its length -
touches the floor.
NOTE
Solution flow setting is stored into memory, even if the machine is turned off.
CAUTION!
To avoid any damage to the floor surface, turn off the brushes/pad-holders when the machine stops in one place,
especially when the extra pressure function is on.
Adjustment of the detergent concentration in the solution
(For machine with EcoFlex™ system)
The system for mixing the detergent in the washing water is automatically activated when the brush is running. The percentage of
detergent added to the washing water is set to level 1 (Fig. 6). By pressing the switch (58), it is possible to set the percentage level to
level 2 or reset it to level 0. The set percentages are shown on the display (60-H)
NOTE
Detergent percentage setting is stored into memory, even if the machine is turned off.
EcoFlex™ system
Press the EcoFlex™ switch (58) when stronger washing power is needed temporarily.
With the EcoFlex™ system activated (LED flashing), increased solution flow, activation of the extra pressure of the brush and an
increase in the solution detergent concentration (level 2 if the level was set to 1 - level 1 if the level was set to 0) is obtained. Press the
EcoFlex™ switch (58) again, to restore the original settings (LED on).
NOTE
If the switch (58) is not pressed once again, the original settings are restored automatically after 60 seconds.
NOTE
All of the above solution flow and detergent concentration values are factory settings.
To change these settings, see the Supervisor key paragraph in Maintenance chapter.
SC650 66D - SC650 71D - SC650 85D - SC650 71C
2.55 cl/m
5.1 cl/m
2.75 cl/m
5.5 cl/m
3.25 cl/m
6.5 cl/m
2.75 cl/m
5.5 cl/m
Figure 5
Figure 6
INSTRUCTIONS FOR USE
3.8 l/min
55943387
ENGLISH
OFF
21