ENGLISH
Batteries (WET) installed on the machine, but without electrolyte.
1.
Open the cover (22) and check that the recovery tank (21) is empty, otherwise empty it with the drain hose (16).
2.
Grasp the handle (41) and carefully lift the tank (40).
3.
Remove the caps of the batteries (51).
WARNING!
Pay attention when using sulphuric acid, as it is corrosive. If it comes in contact with skin or eyes, rinse
thoroughly with water and consult a physician.
Batteries have to be filled in a well-ventilated area. Wear protective gloves.
4.
Fill up the battery cells with sulfuric acid for batteries (density 1.27 to 1.29 kg at 25 ° C) as shown in the Battery Manual. The
correct quantity of sulfuric acid is shown in the Battery Manual.
5.
To avoid damaging the floor, dry with a cloth both acid and water on the top of the batteries after charging.
6.
Let the batteries rest and fill in with sulfuric acid in accordance with the instructions shown in the Battery Manual.
7.
Charge the batteries (see the procedure in Maintenance chapter).
Without batteries
1.
Buy appropriate batteries (see the Technical Data paragraph).
2.
For battery choice and installation, apply to qualified battery Retailers.
3.
Set the machine according to the type of batteries installed (WET, GEL, GEL-AGM, TPPL OR LI-ION batteries) as shown in the
following paragraph.
BATTERY INSTALLATION AND BATTERY TYPE SETTING (WET, GEL, GEL-AGM, TPPL OR LI-ION
BATTERIES)
Battery installation
1.
Open the cover (22) and check that the recovery tank (21) is empty, otherwise empty it with the drain hose (16).
2.
Grasp the handle (41) and carefully lift the tank (40).
3.
Install the batteries.
Battery type setting
1.
Set the battery type (see the procedure in SUPERVISOR SETTING chapter).
Battery charging
1.
Charge the batteries (see the procedure in Maintenance chapter).
BEFORE MACHINE START-UP
WARNING!
When the machine is to be started by pressing switch (66), make sure that, between the deck (18 or 19) and the
above tank assembly, there is no foreign material which may prevent the deck from lifting. This procedure must be
performed because if the machine has been turned off without lifting the deck, the deck would lift automatically at
next machine start-up.
WARNING!
Before turning on the deck lifting/lowering switch (61), always check that, between the deck (18 or 19) and the
above tank assembly, there is no foreign material which may prevent the deck from lifting.
16
INSTRUCTIONS FOR USE
55943387
SC650 66D - SC650 71D - SC650 85D - SC650 71C