Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
BATTERY CHARGING
NOTE
Charge the batteries when there is only one flashing segment displayed in the battery symbol (60-C), or at the end of the
shift.
CAUTION!
Keeping the batteries charged make their life last longer.
CAUTION!
When the batteries are discharged, charge them as soon as possible, as that condition makes their life shorter.
Check for battery charge at least once a week.
WARNING!
WET battery charging produces highly explosive hydrogen gas. Charge the batteries in well-ventilated areas and
away from naked flames. Do not smoke while charging the batteries.
While charging the battery, always keep the tank assembly open.
WARNING!
Pay careful attention when charging the batteries as there may be battery fluid leakages. The battery fluid is
corrosive. If it comes in contact with skin or eyes, rinse thoroughly with water and consult a physician.
Preliminary procedures
1.
Open the cover (22) and check that the recovery tank (21) is empty, otherwise empty it with the drain hose (16).
2.
Drive the machine to the appointed recharging area.
3.
Turn off the machine.
4.
Grasp the handle (41) and carefully lift the tank (40).
5.
For WET batteries only:
•
Check the level of electrolyte inside the batteries (51); if necessary, top up through the caps.
•
Then leave all the caps open for battery charging.
•
If necessary, clean the upper surface of the batteries.
6.
Charge the batteries according to one of the following procedures, depending on the presence of the battery charger.
Charging the batteries with an external battery charger
1.
Check that the battery charger is suitable by referring to the Battery Charger Manual. The battery charger voltage rating is 24 V.
2.
Disconnect the battery connector (12) and connect it to the external battery charger.
3.
Connect the battery charger to the electrical mains.
4.
After charging, disconnect the battery charger from the electrical mains and from the battery connector (12).
5.
(For WET batteries only):
•
Check the level of electrolyte inside the batteries and close all the caps.
•
Then leave all the caps open for battery charging.
•
If necessary, clean the upper surface of the batteries.
6.
Connect the battery connector (12) to the machine.
7.
Grasp the handle (41) and carefully lower the tank (40).
Battery charging with (optional) battery charger installed on the machine
1.
Connect the battery charger cable (6) to the electrical mains (the electrical mains voltage and frequency must be compatible with
the battery charger values shown on the machine serial number plate (34)).
When the battery charger is connected to the electrical mains, all machine functions are automatically cut off.
2.
When the first or second segment from the left in the battery symbol (60-L) is flashing, this means that the battery charger is
charging the batteries.
When the third segment from the left in the battery symbol (60-L) is flashing, this means that the battery charger is finishing the
battery charging cycle.
When all segments of the battery symbol (60-L) are steadily lit, the battery charging cycle is complete.
3.
When the battery charging is completed, disconnect the battery charger cable (6) from the electrical mains and wind it round its
housing (7).
4.
Grasp the handle (41) and carefully lower the tank (40). NOTE
NOTE
For further information about the operation of the battery charger (5), see the relevant Manual.
SC650 66D - SC650 71D - SC650 85D - SC650 71C
INSTRUCTIONS FOR USE
55943387
ENGLISH
25
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
