Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
BRUSH/PAD-HOLDER/CYLINDRICAL BRUSH DECK DISASSEMBLY/ASSEMBLY
The machine can be equipped with either the brush/pad-holder deck (18) or the cylindrical brush deck (19).
NOTE
When the deck is installed/removed, it may be necessary to change the squeegee too, because they must have the same
width. For correct matching of deck and squeegee, see the Squeegee Installation paragraph.
Disassembly
1.
Drive the machine on a level floor.
2.
Remove the brushes/pad-holders according to the procedure shown in the relevant paragraph. Do not remove the cylindrical
brushes.
3.
Turn on the machine by pressing the switch (66).
4.
Lower the brush/pad-holder deck by pressing the switch (61).
5.
Turn off the machine by pressing and holding the switch (66) for nearly a second.
6.
Remove the safety pins (A, Fig. 13) and [for brush/pad-holder deck (18) only] the mounting pin (B).
7.
Open the cover (22) and check that the recovery tank (21) is empty, otherwise empty it with the drain hose (16). Close the cover
(22).
8.
Grasp the handle (41) and carefully lift the tank (40) to reach the deck electrical connection.
9.
Disconnect the red connector (C).
10. Disconnect the solution hose union (D).
11. Unscrew the mounting handwheel (E), then remove the brush/pad-holder deck (F).
Assembly
12. Assemble the components in the reverse order of disassembly, and note the following:
•
When the brush/pad-holder deck (18) is installed, fasten the lever with the pin (B).
SC650 66D - SC650 71D - SC650 85D - SC650 71C
INSTRUCTIONS FOR USE
Figure 13
55943387
ENGLISH
31
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
