Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5. Press the spindle lock button and rotate
the wire brush on the mounting spindle.
Tighten the wire brush using a combination
wrench. You can now release the spindle
lock button.
˜ Operation
CAUTION! Risk of injury!
m
Always remove the mains plug
u
working on the product.
Only use grinding discs and accessories
u
recommended by the manufacturer.
Using other attachment tools and other
accessories can represent a risk of injury
for you.
Only use accessory parts which bear
u
information about the manufacturer, type
of connection, dimension and permitted
number of revolutions.
Only use accessory parts where the
u
printed rotational speed is at least as
high as what has been specified on the
name plate of the product.
Do not use any broken, cracked, or
u
otherwise damaged grinding discs.
Never operate the product without
u
protective equipment.
Support the plates or workpieces in order
u
to reduce the risk of kickback from a
jammed cutting disc. Large workpieces
may bend under their own weight. The
workpiece must be supported on both
sides of the disc, not only near the cutting
disc, but also at the edge.
Keep your hands away from the disc
u
when the product is in operation. Risk of
injury.
NOTE
Information on replacement
Never operate the product without
u
protective equipment.
Ensure that the rotation speed stated on
u
the tool is the same or higher than the
nominal idle speed of the product.
before
[
]
Ensure that the tool dimensions match
u
those of the product.
Only use flawless discs (ringing test:
u
when you strike the grinding disc with
a plastic hammer, it results in a clear
sound).
Never re-drill a locating hole which is too
u
small to make it larger.
Never use separate bushings or adapters
u
in order to make grinding discs with a
hole that is too large fit the product.
Do not use any saw blades.
u
To clamp the grinding tools only use the
u
clamping flange provided. The pads
between the clamping flange and the
grinding tools must be made of elastic
materials e.g., rubber, soft cardboard etc.
Reassemble the product completely after
u
replacing the tool.
m
WARNING!
m
WARNING!
Switch off the product and remove
the mains plug. Allow the product to
cool down.
Wear protective gloves when
changing the tool so as to avoid
injuries from cuts.
GB/IE/NI
19
Advertenties
Hoofdstukken
Inhoudsopgave
