Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
When wheel is binding or when
3)
interrupting a cut for any reason,
switch off the power tool and
hold the power tool motionless
until the wheel comes to a
complete stop. Never attempt to
remove the cut-off wheel from
the cut while the wheel is in
motion otherwise kickback may
occur. Investigate and take corrective
action to eliminate the cause of wheel
binding.
Do not restart the cutting
4)
operation in the workpiece. Let
the wheel reach full speed and
carefully re-enter the cut. The
wheel may bind, walk up or kickback
if the power tool is restarted in the
workpiece.
Support panels or any oversized
5)
workpiece to minimize the
risk of wheel pinching and
kickback. Large workpieces tend to
sag under their own weight. Supports
must be placed under the workpiece near
the line of cut and near the edge of the
workpiece on both sides of the wheel.
Use extra caution when making
6)
a "pocket cut" into existing walls
or other blind areas. The protruding
wheel may cut gas or water pipes,
electrical wiring or objects that can cause
kickback.
Additional safety instructions for
wire brushing operations – Safety
warnings specific for wire brushing
operations
Be aware that wire bristles are
1)
thrown by the brush even during
ordinary operation. Do not
overstress the wires by applying
excessive load to the brush. The
wire bristles can easily penetrate light
clothing and/or skin.
14 GB/IE/NI
If the use of a guard is
2)
recommended for wire brushing,
do not allow any interference
of the wire wheel or brush with
the guard. Wire wheel or brush may
expand in diameter due to work load and
centrifugal forces.
Additional angle grinder warnings
1)
Connect the product only to a power
socket with a residual current circuit
breaker of rated residual current no more
than 30 mA.
2)
Keep power cords and extension cords
away from the disc. If they are damaged
or cut through, immediately pull the plug
from the outlet. Do not touch the cable
before it has been disconnected from the
power supply. Risk of electric shock!
3)
If the replacement of the supply cord is
necessary, this has to be done by the
manufacturer or his agent in order to
avoid a safety hazard.
4)
Only use grinding wheels where the
indicated rotational speed is at least as
high as what has been specified on the
name plate of the product.
5)
Carry out a visual inspection of the
grinding wheel before use. Do not use
any damaged or deformed wheels.
Replace any damaged or worn wheels.
6)
Make sure that the sparks produced
by grinding do not present a danger,
e.g. reach people or ignite flammable
substances.
7)
Always wear safety goggles, safety
gloves, respiratory protection and ear
protection when grinding.
8)
Never keep the fingers between the wheel
and spark protection or in close proximity
to the protective hoods. There is a risk of
crushing.
9)
The rotating parts of the product cannot
be covered due to functional reasons.
Therefore, proceed cautiously and hold
the workpiece firmly in order to avoid
slipping which could cause your hands to
come into contact with the wheel.
Advertenties
Hoofdstukken
Inhoudsopgave
