Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
♦
Now connect the other end
of the compressed-air hose to
the (filter) pressure reducer on
the compressor .
Changing a tool
Always disconnect the grinder
from the compressed air supply
before changing tools .
Only use suitable tools . Ensure
that the minimum clamping length
of the shank in the chuck is
complied with (see fig . 1) .
♦
Using the spanners included
in the accessories, hold the
spindle and chuck
and open or close the chuck
in the direction of the
arrows (see fig . 2) .
CLOSE
Fig . 2
♦
Now insert one of the 10
different whetstones
■
14
│
GB │ IE │ NI
NOTE
►
♦
Operation
firmly
Switching the grinder
on and off
Use the pressure reducer to set
the correct working pressure . Op-
erate the appliance at a working
pressure of maximum 6 .3 bar .
NOTE
►
OPEN
.
Please note the danger
caused by mismatching the
diameter of the grinding tool
shaft and the chuck . Incor-
rectly fitted grinding tools
can cause severe vibrations
– there is a risk of injury!
Ensure that the grinding tool is
correctly fitted, and carry out
a 30 second trial run in a safe
area at idling speed .
An excessive working
pressure does not improve
performance; it merely
increases compressed air
consumption and increases
wear on the appliance .
PDMS 6.3 A1
Advertenties
Hoofdstukken
Inhoudsopgave
