Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
■
Ensure that the maximum
permissible pressure on the
machine is not exceeded .
■
Never carry com-
pressed-air-powered machines
by the hose .
Hazards caused by
accessories
■
Disconnect the grinder for
whetstones from the pow-
er supply before fitting or
replacing the machine tools or
accessories .
■
Use only accessories and
consumables of the size and
type recommended by the
manufacturer of the grinder for
whetstones .
■
Avoid direct contact with the
machine tool during and after
use, as it may have heated up
or have become sharp .
■
The maximum operating
speed recommended by the
manufacturer of the grinder for
whetstones must be the same
or higher than the rotation-
al speed labelled on the
machine .
■
12
│
GB │ IE │ NI
■
Never fit a grinding disc,
cutting disc or milling cutter
to a grinder for whetstones . A
shattering grinding disc can
cause serious injuries or death .
■
Do not use discs which are
damaged, cracked or could
have been dropped .
■
Only approved machine tools
with the correct shaft diameter
may be used .
■
Please note that you must
ensure that the per missible
rotational speed of small grind-
ing tools is reduced due to
raising the position of the shaft
between the end of the chuck
and the small grinding tool
(overhang) . Ensure that the
minimum clamping length of
10 mm is observed
(see figure 1) .
min. 10 mm
Fig . 1
PDMS 6.3 A1
Advertenties
Hoofdstukken
Inhoudsopgave
