Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3.4 Adjusting the seat height
Your flatbed is equipped with a quick release clamp (1).
You can adjust the height with the clamp bolt and/or
the quick release clamp
3.4.1 Opening and locking the quick release
Swing the quick-release lever outward. Adjust the seat
tube to the desired height. Note the instructions for the
minimum insertion depth on page 20. Rotate the quick
release lever inward until it is against the seat tube in
order to close the seat tube clamp. If you are not able
to swing the quick-release lever to the seat post, you
can reduce the pre-load by turning the adjusting screw
in an anti-clockwise direction. Rotate the quick release lever inwards once again until it is connected to the
seat post, in order to close the seat tube clamp.
Check whether the seat can not be turned.
●
Check whether unusual sounds are emitted when opening or locking the quick release.
●
Remove any soiling from the quick release with the help of a clean cloth.
●
If the quick release is not properly locked to the seat tube, the seat may become loose or be released during
your ride. Before riding away, ensure that the quick-release lever is locked with sufficient pre-tension by
tightening of the clamp bolt and is connected against the seat-tube. If you operate the quick release in an
improper manner, you may squash your fingers or other body parts. Therefore always operate the quick
release with care.
3.4.2 Opening the quick release:
Pull the quick-release lever (1) outwards from the corresponding frame part in order to open it.
●
3.4.3 Locking the quick release:
Push the quick-release lever (1) in the direction of the corresponding frame part so that it is against the
●
seat post, in order to lock the quick release.
If you notice that the seat tube is not firmly fastened while the quick release is closed, adjust the quick
●
release correctly.
19
Advertenties
Hoofdstukken
Inhoudsopgave
