Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
E N
B E F O R E C O M M I S I O N I N G
Before commisioning
Before every start up, all essential parts of the high-pressure cleaner must be
checked, by taking them in consideration like for example: is the lance coupling
tight, check the high pressure hoses and the electrical wiring on damages.
Check, before plug in the plug in the socket or the electric indications on the
name plate are suitable with the values of the main power supply (for example:
elektric tension,...) (if applicable). Operate the machine. Rinse the hoses,
spray gun and lance minimum 1 minute with clean water (aim the spray gun in
free space). Check whether hazardous substances such as asbestos and oil
can come loose from the object to be cleaned and pollute the environment.
Persuade yourself of the safety requirements mentionned in previous chapter.
Leave the main switch / key switch on position 0- OFF. Before putting into
use: close the protective cap (if applicable) & at option tarpaulin (if applicable):
dismount the tarpaulin.
ACCOMPLISH WATER SUPPLY AND WATER DISCHARGE
11
Accomplisch water supply
The water supply line can be connected (according circumstances) on their
own water supplies (under pressure, ...) or on a drinking water supply with a
water barge. When the machine is connected to the drinking water supply, the
existing regulations about that must be observed (EN 1717). If necessary place a
filter in the water supply line.
• Water supply under pressure:
Maximum hose length 50 m (160 ft), minimum hose diameter (internal) 12.7
mm (1/2").
Check the water pressure by means of a watermeter.
• Water supply at units with HT- pumps:
When the unit has a HT- pump a pre-pressure pump must be installed.
12
Discharging water
Verify whether all water drains are correctly connected to the sewer system.
Take the necessary measures to ensure that the waste water is pure enough to
discharge/drain.
13
Anti- legionella bacterium measure
If the machine has estood still some time, the water in the machine must be
discharged above a drain.
Stagnant water that is warm between 20-55 ° C can cause the legionella
bacterium.
• Clean therefore the pipes and vessels annually.
• Rinse periodically.
• Remove possible sediment.
1
Filling the fuel tank
The cleaner will be delivered with empty fuel tank, fill the tank with the right
fuel before the first use. Avoid mess of fuel, certainly on warm machine parts.
Respect the fill capacity of the fuel tank. Fill the tank with gasoline/petrol. Use
clean, fresh, unleaded gasoline. A minimum of 87 octane/87 AKI or higher -
RON: min. 90. Gasoline with up to 10% ethanol (gasohol) - 90% lead-free is
acceptable (E0-10).
Pay attention: fuel can become stale when stored over 30
days. Do not mix oil in gasoline or modify the engine to
run on alternate fuels.Fill the tank of the diesel unit with
light fuel oil or diesel oil (DIN 51 603).Don't use unsuitable
fuel! See technical data for tank volume and fuel type.
At temperatures under 8°C the fuel starts coagulate (paraffin
dissidence). As a result, difficulties can arise at starting the diesel
engine and/or burner. DiBO advise to add an coagulation point - or
flow improvement during the cold period (winter months) to the fuel.
As an alternative "winter diesel" can be refuelled in a filling station.
DiBO 14
Advertenties
Hoofdstukken
Inhoudsopgave
