Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
E N
S E R V I C E
4
High and low pressure part
Check the hoses, piping and connections on external damages and leaks.
If damaged or leaks these must be immediately replaced.
5
Spray tools
Check lances and guns on leaks, external damages and hair cracks. If damaged
or leaks these must be immediately replaced. Check the spray image of the
water jet, if these blows out to much you must replace the nozzle.
Check protective cap-nozzle on damages and replace if necessary.
Check the thread of the couplings on external damages.
At damage let these replace without delay.
6
Electrical part
Checks visible electric wiring and components (among other things switches) on
external visible damages. If damaged let replace the concerning parts.
7
Engine
• Engine oil: check the oil level with the level stick (to see guide engine).
• Reduction gearbox: check the oil level of the reduction gearbox.
• Air filter: check or there sits no clogging for the air opening.
• Fuel filter: check on clogging and possibly clean or replaced.
See the special instructions in the engine manual (delivered).
8
Oil drain / filling high pressure pump
• Oil drain: put a oil trough under the drain plug. Remove the drain plug.
Let all the oil in the oil trough. Assemble the drain plug (with a new packing
ring). Pour the tapped oil in a can. Deliver the tapped oil by your dealership or
at the proper authorities.
• Oil filling: remove the oil level gauge. Fill the engine crankcase with oil until
the oil level reaches to the middle of the gauge (type oil see technical data).
Check the oil level by the marks on the oil level gauge.
Place the oil level gauge back.
9
Battery
At electric driven machine, a battery is present. Check the battery on good
connections / possible wear and whether the battery needs to be recharged.
If the idling battery voltage drops below: 12.6 V (or if stored / not used during 6
months), this must be recharged. This can happen by means of a trickle charger,
standard charger or workhouse charger. Reloading need to be done by a
qualified technician.
Caution: Ventilate sufficiently when reloading battery,
avoid risk of sparks (no smoking), care for a good
electrical connection of the charger & the battery!
10
Purging the softener pump
The softener hose pump does not need to be purged.
Regularly clean the vent cap, remove product residues!
DiBO 30
Advertenties
Hoofdstukken
Inhoudsopgave
