Inspired by life
Adjusting the width position of the side shield
1. Lift the T-piece armrest out of the side holder.
2. Remove the height stop from the T-piece by
loosening the Allen screw.
3. Slide the mounting blocks (A) out of the insertion
tube of the armrest and split it into 4 loose
blocks.
4. Slide the 2 threaded mounting blocks into the
plug-in tube.
5. Place the 2 additional blocks on the 2 threaded
mounting blocks and place the side shield on
top.
6. Assemble this assembly with the 2 bolts sup-
plied.
Fix the armrest
1. Slide a thin square nut down behind the height
stop.
2. Insert a countersunk bolt (D) into the hole and
tighten the bolt into the square nut.
Adjusting the depth of the side shields.
1. Remove the 2 countersunk bolts (C).
2. Place the side shield in the desired position.
3. Retighten the 2 countersunk bolts (C).
Adjusting the height of the side shields.
1. Loosen the 2 countersunk bolts (C).
2. Slide the side shield up or down.
3. Retighten the 2 countersunk bolts. (C)
Replace the armrest
1. Remove the 2 countersunk bolts (E) on the
bottom of the armrest.
2. Remove the armrest and replace it with a new
one.
3. Retighten the 2 countersunk bolts (E).
EN26
E
E
C
C
B
B
A A
D D
Leg rests
Swivel and/or remove the leg rests
1. Pull the lever (C) upwards and rotate the legrest
outwards or inwards at the same time.
2. If the leg rest is turned outwards, it can be lifted
straight up from the frame.
Positioning the leg rests
1. Rotate the leg rest a quarter turn outwards from
C
C
the mounted position and lower it into the ope-
ning provided
2. Rotate the leg rest forward until it clicks into place.
Warning:
•
If a push brake is fitted, make sure that the
leg rest cannot unintentionally release the tire
brake when swinging outwards.
Adjusting the lower leg Length
1. Loosen the Allen screw (D)
2. Slide the insert tube further in or out of the sus-
pension tube until the desired lower leg length is
reached.
Note:
D D
•
It is advised to keep at least 5 cm of verti-
cal distance between the footplate and the
ground.
3. Tighten the Allen screw (D).
Adjusting the Knee Angle
1. Remove the countersunk bolt (A) in the ankle joint
and footplate
2. Loosen the Allen screw on the underside of the
leg rest (B).
3. Remove the single pivot point from the plug-in
tube and rotate it 180 degrees.
4. Replace the single pivot point in the plug-in tube
B B
and re-tighten the Allen screw (B).
5. Replace the footplate against the pivot point and
A A
retighten the countersunk bolt (A) in the ankle
joint.
EN27