Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Inspired by life
B. Seat upholstery adjustment
1. Slide the two upholstery rails (A) into the correct
seat width size indication (C) on the end of the
seat width tunnels (B) of the upholstery.
2. Fold the end of the upholstery around the rails.
Make sure that the rails themselves are not
folded over, so the 'fold line' is outside the rails,
see also the size indication numbers on the
upholstery (C)
3. Place the left and right upholstery tools on the
end of the frame tubes.
4. Fold the folding frame slightly, just like the back
frame, and slide both rails (with the upholstery)
into the tubes of the seat frame at the same
time, using the upholstery tool
5. Screw the upholstery screws on the front of the
upholstery into the tunnels where the upholstery
rails are located.
6. Replace the cover caps (X) at the ends of the
seat frame tubes.
C. Back upholstery adjustment
1. Slide the upholstery tendon (A) into the correct
back width size indication (C) on the back width
tunnels (B) of the upholstery.
2. Fold the end of the upholstery around the rails.
Make sure that the rails themselves are not
folded over, so the 'fold line' is outside the rails,
see also the size indication numbers on the
upholstery (C)
3. Fold the folding frame slightly, just like the back
frame, and slide both rails into the tubes of the
back frame at the same time, using the uphol-
stery tool
4. Tighten the upholstery screws on both sides of
the front of the upholstery in the tunnels where
the upholstery rails are located.
5. Replace the cover caps (Y) on the top and
bottom of the left and right back tube.
EN20
C
C
A A
B B
C C
B
B
A A
Y
Y
Seat depth
The seat depth can be adjusted by stepless sliding
the rear module over the side frame.
1. Loosen the 4 Allen screws (A to D) on both sides.
2. Slide the rear module over the side frame to
A A
B B
the desired seat depth position (see seat depth
indication on the inside of the upper seat frame
tube).
3. Retighten the 4 Allen screws (A to D) on both
sides. (tightening torque 10Nm)
C
C
D D
Warning:
•
Make sure the rear module is mounted at the
same depth on the left and right.
•
If the position of the back frame prevents you
from sliding the rear module to the correct posi-
tion, adjust the back depth position according to
the instructions on p. 22.
Seat depth adjustment range per side frame:
•
Short frame: SD 40 cm - SD 48 cm
•
Long frame: SD 46 cm - SD 56 cm
Back Depth Position / Fine Adjustment of Seat
Depth
The position of the back support can be adjusted
extra precisely by moving the back tubes over the
seat frame tube (inside the rear module). The middle
position between the rear module is the standard
position.
1. Loosen the 2 Allen screws (C) of the back depth
C C
adjustment.
2. Slide the back tubes tubes to the desired depth
position.
3. Retighten the 2 Allen screws (C). (tightening
torque 10 Nm)
Warning:
•
Make sure the back tubes are mounted at the
same depth on the left and right.
EN21
Advertenties
Hoofdstukken
Inhoudsopgave
