Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Inspired by life
3. Retighten the 2 Allen screws (A).
4. Repeat for the other front wheel.
Adjusting the height position of the front wheel in
the fork
1. Loosen the front wheel axle nut and remove the
axle.
2. Place the front wheel back in the desired height
position according to the NEOX frame height
table or the advice of the NEOX configurator.
3. Replace the shaft and tighten the nut.
Frame height at the back of the wheelchair
1. Remove the rear wheel by pressing the button in
the middle of the wheel.
2. Loosen the 2 axle plate bolts (A & B) and remove
the axle plate from the rear module.
3. Place the axle plate in the correct height position
on the rear module according to the NEOX
frame height chart or the advice from the NEOX
configurator, insert the 2 Allen screws (A & B)
and tighten them. (tightening torque 10Nm)
4. Insert the rear wheel back into the axle bushing
(C).
5. Repeat for the other rear wheel.
Note:
•
Make sure the left and right axle plates are
mounted at the same height.
•
After adjusting the frame height, always check
the head angle adjustment and the adjustment
of the tire brakes (see page 23 onwards)
EN18
1
2
3
4
5
Positions 1 to 5 correspond to the
height of the wheel in the clevis.
A A
B B
C C
Seat width and back width
A. Frame Settings
The seat width of the wheelchair is adjustable by the
width-adjustable folding frame and the width-adjus-
table upholstery. And can be adjusted in steps of 2.5
cm from 34.5 cm to 57 cm.
The size 1 folding frame has an adjustment range of
34.5 to 49.5 cm. And the folding frame size 2 has an
adjustment range of 42 to 57 cm.
Adjusting the seat width of the folding frame
1. Remove the seat cushion.
X X
2. Remove the cover caps (X) and the upholstery
screws on the front and rear of the seat frame
tubes and the top and bottom of the back tubes
A A
B B
C C
D D
3. Slide the upholstery rails with the upholstery
forwards out of the seat frame tubes and up out
of the back frame tubes.
E E
F F
4.
Loosen the 6 Allen screws (A to F) of the folding
frame.
5. Extend the folding frame to the desired seat
X
X
width (teeth for every 1.25 cm, resulting in
increments of 2.5 cm at a time). See the table on
the right for which number of the folding frame
1
W34,5
should be visible for which seat width.
2
W37
3
W39,5
Waarschuwing:
4
W42
•
5
W44,5
6
W47
7
W49,5
8
W52
6. Retighten the 6 Allen screws (At/m F). (tightening
9
W54,5
torque 10 Nm).
10 W57
Make sure that the left and right sides of the
folding frame are set to the same number of
teeth.
EN19
Advertenties
Hoofdstukken
Inhoudsopgave
