Advertenties
Beschikbare talen
Beschikbare talen
10.3
Setting the setpoint source
Setpoint source
Internal setpoint
Analogue input (AI2)
CIF module
Fig. 42: Setting the setpoint source
10.4
Emergency operation
Installation and operating instructions • Wilo-Yonos GIGA2.0-I/-D • Ed.02/2023-08
Universal
Setpoint =
2
1.1.3 Kp
2
1.1.4 Ti
2
1.1.5 Td
2
1.1.6
OFF
ON
2
The menu item only opens if control mode PID is set.
NOTICE
The setpoint can only be adjusted if the setpoint source is set to "Internal
setpoint".
If "Internal setpoint" has not been selected in the "Setpoint source"
menu, the green adjustment bar in the "Setpoint" menu is not active. No
setting can be changed.
To set the setpoint source, select the following in succession:
Universal
1.0
1.1
1.1.9
The following setpoint sources are available to select from:
Universal
1.1.9 / 1
1.1.9 / 2
1.1.9 / 3
The setpoint source "Internal setpoint" can be set in the display. The setpoint sources "Ana-
logue input AI2" and "CIF module" expect a setpoint from an external source.
NOTICE
A CIF module can only be selected as a setpoint source if a CIF module is
installed. The menu item cannot otherwise be selected.
If the setpoint is set via the analogue input AI2, the analogue input can be
configured in the "Settings" menu.
If an external setpoint source (analogue input AI2 or CIF module) is selected, the menu item
"Substitute setpoint" opens. A fixed setpoint can be specified here, which is used for control
in the event of a malfunction of the setpoint source (such as a cable break at the analogue
input or no communication to the CIF module).
After confirming the selected setpoint source, the "Control setting" menu opens again.
In the event of a malfunction (such as failure of the required sensor) an "emergency opera-
tion" can be defined. (Only adjustable for control modes Δp-v and Δp-c)
Display text
Setpoint =
2
Parameter Kp
2
Parameter Ti
2
Parameter Td
2
Control inversion
Inversion OFF
Inversion ON
Display text
Settings
Control settings
Setpoint source
Display text
Internal setpoint
Analogue input (AI2)
CIF module
en
163
Advertenties
