Inhoudsopgave
Advertenties
•
Push the choke lever (14) back in
•
Pull out the pull starter (6) evenly to the stop until the engine starts
•
Release chain brake (10)
•
Operate the throttle lever (16) slightly
36. Warm start
•
Set ignition switch (3) to [1]
•
Pull out the pull starter (6) evenly to the stop until the engine starts
•
Operate the throttle lever (16) slightly
•
Release chain brake (10)
•
If the engine does not start after pulling the pull starter three times, repeat the
entire starting procedure as described under Cold Start
After starting
•
Run the engine at idle speed for some time
•
Press the throttle slowly to increase the engine speed
When the engine speed is high enough, the clutch disengages and the saw-chain starts to
rotate.
•
Ensure that the chain is sufficiently lubricated (► Check chain lubrication)
•
Check that the chain stops spinning when the throttle is released
Switching off the engine
•
Release the throttle lever
•
Set ignition switch to [0].
The engine switches off.
DANGER!
Danger of injury!
The throttle stick must be pressed lightly once after starting, so that the engine reaches the
correct idle speed and the saw-chain does not start up in idle speed.
Hint:
Pull the pull starter with the choke lever pulled only until the first ignition noise is heard.
Otherwise there is a risk that too much fuel will enter the combustion chamber and no ignition
spark can be produced.
NOTE:
Always drain the appliance before turning it off
Manual_FX-KS226_Int24_rev3
52
Advertenties
Inhoudsopgave
Probleemoplossen
