Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3- The two minute digits are flashing.
Set the minutes with
Confirm by pressing
1
4- The cursor above the 1 represents Monday.
Set the day with
or
Confirm by pressing
1
5- To change and/or assign programmes press
To exit the time and day setting mode, press 3 times
• Programme choices
Programme sequencing scheme:
Auto
Comfort
Version with presence/absence detector: the product
is delivered by default in self-programming (Auto)
described on page 18. If this program suits you, you
have nothing else to do, the device, after a learning
phase, will program itself according to your life
rhythm.
Other version: The product is delivered by default in
Permanent comfort for all days of the week.
• Presentation of the programmes
- Auto: Auto-programming, (see automatic programming:
Auto-adaptive programming page 18).
- Comfort: your appliance operates in Permanent Comfort
for the 24 hours of the selected day.
Note: You can set the Comfort temperature
(see Comfort temperature setting on page 17).
- Eco: your appliance will run in permanent Eco mode for the 24 hours
of the selected day.
Note: You can adjust the Eco setback level (see
Adjusting the Eco set-back level on page 14).
- P1: your appliance operates in Comfort mode from 6am to 10pm
(Eco from 10pm to 6am).
- P2: your appliance operates in Comfort mode from 6am to 9am and
from 4pm to 10pm (Eco from 9am to 4pm and from 10pm to 6am).
- P3: your appliance operates in Comfort mode from 6 to 8 a.m., from
12 to 2 p.m. and from 6 to 11 p.m.
(Eco from 11 p.m. to 6 a.m., 8 a.m. to 12 noon and 2 p.m. to 6 p.m.).
• Possible changes to the programmes
If the default times for P1, P2 and P3 do not suit you, you can change
them.
Changing P1, P2 or P3.
If you change the schedules of P1, P2 and P3, the
schedules are changed for all days of the week where
P1, P2 and P3 are assigned.
or
.
.
1
.
.
1
Eco
P1
P2
1- If you have just set the time and day, go directly to step
2.
If you are in Auto, Comfort, Eco or Frost protection mode,
press
for 5 seconds.
Once the cursor is positioned under the time setting
symbol
, press
2
2- Press
under prog.
2
3- Use
or
.
P1 flashes. To change, hold down the
.
for 5 seconds.
P3
4- The start time of P1 (default 6:00) flashes.
With
or
intervals.
Confirm by pressing
5- The end time of P1 (default 10pm) flashes. With
or
, you can change this time in 30-minute
intervals.
Confirm by pressing
again briefly
1
or
. The cursor moves to the position
1
to select P1.
1
1
, you can change this time in 30-minute
1
1
key
2
5 sec.
2
2
19
Advertenties
Hoofdstukken
Inhoudsopgave
