Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
LOCK PIN CODE
Selections :
The heater is protected against unauthorised use by a security code. The PIN code
(Personal Identity Number) is a customisable four-digit code which, when activated, prevents access to the following
settings:
- Selection of Comfort mode: Access to Comfort mode prohibited,
Only Auto, Eco and Frost protection modes are accessible.
- Modification of the minimum and maximum stops of the Eco
Comfort setpoint (the Comfort temperature can be changed
(The Comfort temperature cannot be changed outside the permitted setting range). - Selection of the optimisation mode.
When using the "PIN lock" protection for the first time, 3 important steps are necessary:
1- PIN code reset, enter the default PIN code (0000) to access the function.
2- Activate PIN code to lock settings that will be protected by PIN code.
3- To customise the PIN code, replace (0000) with your own four-digit code.
Initiating the PIN code
By default, the PIN code is not activated. OFF appears on the display.
1- By default, the PIN code is not activated. The default PIN code
registered is 0000.
Using
or
select the number 0.
The number flashes, confirm
by pressing
2- For the remaining digits, select the number 0 by pressing
. When 0000 is displayed, press
The PIN code is initialised, the device automatically proposes the
following setting: PIN code activation.
Activation/deactivation of the PIN code
1- OFF appears on the display.
Press
or
to activate the PIN code.
ON appears on the display.
ON = PIN code activated
OFF = PIN code deactivated
2- Press
to confirm and return to the installer settings home
screen.
PIN code customisation
If you have just activated the PIN code, follow the steps described
below. If not, you must repeat the initialisation steps 1 and 2 and the
activation steps 1 and 2 before personalising it. This is because perso-
nalisation can only be done after initialised and activated the PIN code.
1- When On is displayed,
press
for at least 5 seconds.
1
2
again to confirm.
5 sec.
- Modification of the programming.
- Setting of window opening detection.
- Setting of the Eco lowering level.
- Setting the Frost protection setpoint.
2- The code 0000 is displayed and the 1st digit flashes. Using
select the desired digit and press
same way for the remaining 3 digits.
3- Press
to confirm. The new code is now saved.
4- Press
again to exit the PIN setting mode and return to the
installer settings home screen.
Press
twice to exit the installer settings.
RETURN TO FACTORY SETTINGS
If the PIN code protection is disabled, you can reset the
user and installer settings to their original values. From
the PIN code setting, press
rEST is displayed for 1 second. Press
select.
YES = Reset to factory settings
NO = Factory settings not reset
Press
for 5 seconds. The unit returns to its original
configuration and automatically returns to the installer
settings home screen.
The factory settings will then take effect.
to confirm. Proceed in the
1
2
.
or
to
5 sec.
13
or
Advertenties
Hoofdstukken
Inhoudsopgave
