Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
LIMITING THE COMFORT SETPOINT
TEMPERATURE
You can limit the setting range of the set temperature by
setting a maximum and/or minimum stop to prevent any
changes beyond these.
Low temperature limitation
•
A minimum stop is set to prevent the temperature from
falling below the set point. The minimum stop is preset at
7°C. You can vary it from 7°C to 15°C in 1°C steps.
9- To change the minimum stop, press
then confirm by pressing
If you do not wish to change it, press
will automatically propose the maximum stop setting. To
exit the user settings, press
• High temperature limitation
A maximum stop is set to prevent the temperature from
being raised above the set temperature. The maximum
limit is preset at 30°C. You can vary it from 19°C to 30°C
in 1°C steps.
To change the maximum setpoint temperature,
press
or
.
Press the
key to confirm and move to the next
setting. To exit the user settings, press
SETTING THE MAXIMUM ALLOWED
BOOST TIME
The maximum boost time is preset to 60 minutes. You
can vary it from 30 to 90 minutes in 30-minute intervals.
10- The heat and boost indicators are displayed and the
preset time of 60 minutes flashes.
or
.
1
2
: the device
twice.
1
2
twice.
The maximum boost time is preset to 60 minutes. You
can vary it from 30 to 90 minutes in 30-minute intervals.
11- Press
or
12- To confirm and move automatically to the next set-
ting, press
.
To exit the user settings, press
SETTING THE MAXIMUM ROOM TEMPERATURE FOR
AUTOMATIC BOOST SHUTDOWN
When Boost is activated, the blower must heat the room
to a temperature limit: the maximum room temperature.
When this limit is reached, the Boost stops automatically.
It is preset at 35°C, but can be varied from 25°C to 39°C
in 1°C steps.
The heating and boost indicators are displayed and the
temperature flashes.
13- You can set the maximum Boost temperature by
pressing
or
from 25°C to 39°C in 1°C steps
To confirm and move automatically to the next setting
press
. To exit the user settings, press
CHOICE OF TEMPERATURE UNIT
The default temperature unit is degrees Celsius. This
setting is not available in this version.
14- To confirm and automatically advance to the next
setting, press
. To exit the user settings, press
twice.
RETURN TO FACTORY SETTINGS
If the PIN code protection is disabled, you can reset the
user and installer settings to their original values. From
the PIN code setting, press
rEST is displayed for 1 second.
YES = Reset to factory settings
NO = Factory settings not reset
Press
for 5 seconds. The unit returns to its original
configuration and automatically returns to the installer
settings home screen.
The factory settings will then take effect.
to display the desired time.
twice.
.
twice.
15
Advertenties
Hoofdstukken
Inhoudsopgave
