Inhoudsopgave
Advertenties
EN
PRODUCT OVERVIEW
The multifunctional starting device is a portable battery-free solution that enables emergency starting of a vehicle equipped with a
12 V electrical system. The device is equipped with ultra-capacitors which do not require charging from the 230 V mains. Simply
charge the device in a short time from the remaining energy in the discharged vehicle battery or from another charging source for
portable devices using a USB cable. The device is also equipped with a charging function for mobile devices.
Read the entire instructions manual before using the product and keep it for future reference.
The supplier is not liable for any damage resulting from failure to observe the safety instructions and recommendations contained
in this manual.
GENERAL SAFETY CONDITIONS
Safe use instructions
Ensure that the product is not damaged before each use. Any damage to the housing, such as cracks, dents or broken compo-
nents, will render the product unsuitable for further use. Pay particular attention to the condition of the cables and cables con-
nected to the product. If the leads and cables have damaged insulation, the plugs show signs of any damage, cracks, kinks, etc.,
they should not be used. Contact an authorised manufacturer's service centre if damage is found. Do not expose the product to
rain or moisture. Do not immerse the product in water. Moisture in the unit can cause a short circuit, fi re or even explosion. Do not
short-circuit. It is forbidden to place cables, coins, nails, pins, keys and other metal parts in the housing and controls of the device.
It is forbidden to connect the sockets and starting terminals of the device to each other. A short circuit can cause burns, electric
shock, fi re and even explosion. Do not allow the unit to overheat. Do not expose the unit to direct sunlight. Keep the product away
from heat sources. Exposing the product to fi re or high temperatures, above 65°C may cause fi re and/or explosion. Using the
product at temperatures below -40 degrees Celsius will result in a signifi cant reduction in the device's performance or the device
will not be able to meet the requirements of normal use. Follow the recommendations in the charging safety instructions. Do not
store the unit at temperatures outside the range specifi ed in the technical data table. Improper storage, at temperatures outside
the specifi ed range, can damage the battery and increase the risk of fi re. Do not attempt to repair, modify or disassemble the unit's
housing components yourself. Do not place heavy objects on the unit or exert a lot of pressure on the unit housing. For repair,
contact the manufacturer's authorised service centre. Do not expose the unit to excessive shocks, e.g. during transport. The unit
should be protected against falling. If the product is seriously damaged or falls into water, place it in an open area away from
fl ammable materials, people and objects. It should be taken to a professional waste disposal facility. Do not pierce the product. Do
not place the product near a fi re source. Keep the product away from children and animals.
Safety instructions for battery charging
Caution! Before starting charging, make sure that the charger's body, cables and terminals are not cracked or damaged. It is
forbidden to use a damaged product. Do not perform any charging without constant supervision of an adult! If it is necessary to
leave the room or area where charging is taking place, interrupt charging by disconnecting the charger from the product and the
mains supply or disconnecting the jump starter cables from the car battery. If smoke, a suspicious odour, etc. is emitted from the
product, stop the charging process immediately and disconnect the charging cable or starter cables from the car battery. Under
no circumstances should capacitors be discharged by short-circuiting the electrodes, as this causes irreparable damage and may
also result in fi re, electric shock or explosion! In addition, do not check the device charge status by short-circuiting the electrodes
and checking their sparking. Use only the leads supplied with the product to perform jump start. It is forbidden to use extension
leads, other leads or to modify the leads supplied with the product. During jump starting, a high current is transmitted through the
leads. Incorrectly selected or modifi ed leads can lead to an electric shock, fi re, burns, or other injuries. Connect the jump leads and
other cables only for the duration of the product's use. Do not store the product with its the cables still connected. This can cause
short circuit and damage to the product, an electric shock, fi re and even explosion. Do not charge the product if a temperature
alarm has occurred. Wait until the unit has returned to normal operating temperature.
PRODUCT OPERATION
Preparing the product for operation
Unpack the product and completely remove all parts of the packaging. It is recommended to keep the packaging for the purpose
of transporting the product in the future. The product can come with a partially charged capacitors, but it is required to perform full
charging, before the fi rst use.
Charging via USB type C cable
ATTENTION! Do not leave the device unattended while charging.
ATTENTION! Do not use the charging socket for mobile devices when charging the product.
ATTENTION! Any socket and USB cable can be used to charge the product. However, make sure that the current capacity of the
socket and cable is at least equal to the charging current listed in the technical data table.
O R I G I N A L
I N S T R U C T I O N S
10
Advertenties
Inhoudsopgave
