Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
7 | Maintenance
Fig. 48 Celsius / Fahrenheit selection
6.15
Resetting the remote control
To reset the remote control to factory settings:
1.
Take out the batteries and then put them back in. See also
chapter 7.2, "Remote control batteries" on page 16.
2.
Set the clock again. See chapter 6.10, "Setting the system
clock" on page 14.
3.
Activate the timer again, if in use. See chapter 6.12, "Activ-
ating the timer" on page 15.
Fig. 49 Resetting the remote control
6.16
Operating the air distributor
without the remote control
You can control the basic functions of the air conditioner by us-
ing the touch button on the display of the air distributor. This is
useful if you cannot immediately find the remote control or if it
has run out of power.
1.
Press the touch button
each press you cycle through the modes: OFF, COOL, FAN,
HEAT.
Fig. 50 Setting the operation mode
– In cooling and heating mode the setpoint temperature is
automatically set to 24 °C and the fan speed is set to
HIGH.
2.
Use the remote control to select any other temperature or
fan speed.
3.
You cannot select AUTO mode at the air distributor, but
the display will show the "auto mode" icon in the top right
corner if this has been selected through the remote control.
1
2
Fig. 51 Display on the air distributor
16 / 146
at the air distributor display. With
C
3
2
1
Touch button
2
Operation mode symbols
3
Temperature display
6.17
Adjusting the air outlets
Adjust the direction and angle of the air outlet by moving one
blade around its axis. The three blades move together.
Fig. 52 Adjusting the air outlets
7
Maintenance
7.1
Air filter
The return air filters need periodic maintenance.
l Check and clean the filters every week, when in use, to pre-
vent the filters from being blocked by dirt.
l You must wash the filters frequently to ensure effective
cooling and heating.
1.
Pull out the filters (1) from the air distributor (2).
2.
Clean the filters with warm water and detergent.
3.
Let it dry before installing again.
1
Fig. 53 Air filter
1
Fig. 54 Removing the air filters
NOTE
Replacement filters can be ordered separately.
Never operate the air conditioner without a filter. This
can cause fouling of the heat exchanger and lead to a
loss of power.
7.2
Remote control batteries
l Change the remote control batteries (2 x AAA type) when
the display of the remote control becomes unreadable
and / or blurry.
9045225A_OI-II_Cool Top Trail 20G-24G ML
2
1
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
