Inhoudsopgave
Advertenties
Operating but-
Function
tons
9 DIM*
Selects the brightness of the LED lights:
25%, 50%, 75%, 100%
10 LOCK
Disables the touch control on the air dis-
tributor when the unit is ON. Press the
button again to unlock.
11 MODE
Selects the operation mode COOL / DRY /
FAN / HEAT / AUTO.
12 FAN
Selects Low / Medium / High or AUTO fan
speed. AUTO fan speed is only possible in
COOL / HEAT mode. With AUTO fan
speed the fan automatically adjusts
between Low, Medium and High.
13 SLEEP
Selects the sleep mode. Only available in
COOL or HEAT mode.
14 SET TIME
Enters CLOCK / TIMER setting mode.
15 HOUR/MIN
Changes between hour or minutes set-
tings.
16 TIMER
Activates different timer settings.
17 DISPLAY
Switches the display of the air distributor
On / Off.
18 LIGHT*
Switches the LED lights on the air distrib-
utor On / Off.
19 Up / Down
Adjusts the setpoint temperature, clock or
timer.
20 ON / OFF
Switches the system On / Off.
21 °C/°F
Selects the temperature units, Celsius or
Fahrenheit, of the temperature display.
* Only applicable to units with LED lights.
6.6
Switching the unit ON / OFF
To switch the unit on, press the
trol.
Fig. 33 Switching the unit on
l The unit switches on and the display of the air distributor
shows the set temperature and operation mode.
l The display of the remote control shows the set temperat-
ure, operation mode and fan speed level.
l The last settings are retrieved.
l The indoor fan may start immediately if the unit is in fan or
cool mode. If in heating mode there will be a delay while
the inside coil heats up before the inside fan turns on - pre-
venting a cold draft.
l It may take up to 3 minutes for the compressor to start op-
eration. This is a feature to protect the compressor.
To switch the unit off, press the
9045225A_OI-II_Cool Top Trail 20G-24G ML
button on the remote con-
button again.
Fig. 34 Switching the unit off
l The unit switches off, the display of the air distributor
blanks.
l The display of the remote control shows only the clock.
You can also switch the unit on and off by pushing the touch
button
at the air distributor, see chapter 6.16, "Operating
the air distributor without the remote control" on page 16 for
details.
6.7
Setting the temperature
Use the
/
buttons to change the set temperature.
Fig. 35 Setting the temperature
l Both the display of the remote control and the display of
the air distributor show the set temperature.
l The air conditioner confirms receiving each set value
change with a beep.
l You can set the temperature between 16 and 30 °C when
the unit is running.
l You cannot set the temperature in FAN
6.8
Setting the fan speed
Use the FAN button to set the fan speed level.
l The fan speed level directly influences the air flow volume.
l Each push on the FAN button changes the fan level in the
sequence as shown below.
AUTO indicates that the Automatic FAN mode is selected. In
this mode the fan speed adapts automatically. Automatic FAN
mode is only available in operation mode COOL or HEAT.
Fig. 36 Setting the fan speed
6.9
Setting the operation mode
Press the MODE button on the remote control to change the
operation mode. The remote control shows the selected icons.
l Each push on the MODE button changes the mode in the
sequence as shown below.
Operating Instructions | 6
mode.
13 / 146
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
