Inhoudsopgave
Advertenties
– You will hear four clicks of the latches (2) when the air
distributor (1) and the mounting bracket (3) connect to-
gether.
Fig. 27 Attaching the air distributor assembly to the mounting bracket
2.
Fix the air distributor (1) on the air distributor mounting
bracket with four ST4.2 * 19 pan head screws (2).
Fig. 28 Fixing the air distributor assembly to the mounting bracket
– The following step is optional. The purpose of this step
is to close a potential gap between the air distributor
and the ceiling of the vehicle by using 4 countersunk
screws.
– To install these screws:
3.
Attach the air distributor (1) to the ceiling using 4 counter-
sunk screws (2).
Fig. 29 Fixing the air distributor to the ceiling
4.
Install the air filters (2) as illustrated below:
9045225A_OI-II_Cool Top Trail 20G-24G ML
Fig. 30 Installing the air filters
5.16
Installing the remote control
holder
1.
Find a convenient location to install the remote control
holder (1).
2.
Use the 2 countersunk screws (2) to secure the holder.
Fig. 31 Remote control holder
5.17
Testing the system
l Test all air conditioner functions as described in chapter 6,
"Operating Instructions" on page 11.
l Make sure that the condensate outlets are clear after in-
stalling the outdoor unit.
l Enter the new vehicle height and weight in the vehicle doc-
uments if required.
l Hand this document over to the new vehicle owner.
6
Operating Instructions
6.1
Before usage
NOTE
Before switching on, make sure that the supply voltage
and frequency corresponds to the values of the air con-
ditioner.
NOTE
Make sure that the amperage provided by the external
power supply is sufficient.
NOTE
Always completely unwind the cable drum to prevent
the power supply extension cable to the vehicle from
overheating and loosing voltage.
NOTE
The extension cable must have a minimum cross section
of 3x2.5 mm².
NOTE
You must make sure that the air outlet and intake
grilles are not covered by cloths, paper or other objects.
NOTE
After removing the remote control back cover, insert
two (2) AAA LR3 leak-proof batteries into the remote
control. Then replace the cover on the back.
Operating Instructions | 6
11 / 146
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
