Inhoudsopgave
Advertenties
If the synchronization is successful, another beep sounds and the USB symbol is displayed steadily.
The KlimaLogg Pro starts to transfer his datas to the PC.
Initiate contact:
Synchronization is only required once in order to assign the logger to the software. In order to initiate
contact to the software during the next start, it is only necessary to press the USB button once. The
KlimaLogg Pro then attempts to establish the connection for 5 seconds and displays the assignment
received from the software on the text display.
For information about the operating of the PC software, we recommend that you use the manual
(which is available as PDF file at the installation folder of the software) or use the help function in the
PC software.
The data sets that have been recorded are wirelessly transferred to the PC using the USB
transceiver. The average transfer speed is 20 data sets per second. In extreme cases, it can take
almost 45 minutes until all data sets have been downloaded (when the memory is completely
filled).
During radio-clock reception, communication with the USB receiver is not
possible and is interrupted. When reception is successful,
communication is automatically restored again.
OPEN COLLECTOR HARDWARE OUTPUT:
The KlimaLogg Pro has an open collector hardware output. This output has two switching outputs that
react as follows in case of an alarm on channel 1.
Switch point 1, active when the temp. or rH is exceeded on channel 1. Switch point 2, active when the
temp. or rH is undershot on channel 1. A switch point is active as long as the alarm limit is triggered and
deactivated again as soon as the respective value is again within the standard range or the respective
alarm setting is deactivated.
The open collector output has a jack for a 3.5 mm jack plug. The following drawing shows the
configuration.
Grade:
45
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
