Inhoudsopgave
Advertenties
information in learning mode. In learning mode, the serial number of the
entered channel is always displayed for the corresponding channel.
In the channel display, a status information symbol can be displayed for every transmitter. It is a bar
that is displayed under the channel number. If the bar flashes, the batteries of the corresponding
transmitter are weak
and should be replaced (in this case, a "TX" symbol also appears in the
temperature display area when the corresponding channel is selected / displayed). If a bar is
displayed constantly, radio contact to the corresponding transmitter has been interrupted.
After the batteries of a transmitter are changed, we recommend activating the
comprehensive transmitter search in learning mode in
order to re-establish contact as quickly as possible. A transmitter can be entered
into a receiving device for only three hours
after it is started up. The transmitter then only transmits its current measured values a nd
can no longer be entered on a receiving device.
LEARNING MODE:
Learning mode allows you to manually start a transmitter search. It is possible to enter a transmitter
individually on every channel. Furthermore a transmitter that was already entered can be removed.
Press SET button to enter setting mode.
•
CH1-8 and LRN appear in the display.
•
The channel numbers start flashing.
•
If a transmitter is already entered on a channel, a triangle is displayed above the
•
corresponding channel number.
Comprehensive channel search
Press the OK / MAX / MIN button to start a comprehensive transmitter search.
•
LEARNING and the channel numbers appear on the display with a black bar.
•
The KlimaLogg Pro searches for transmitter signals for three minutes.
•
If a transmitter signal is received, the bar under the corresponding
•
channel number disappears.
Transmitters that have already been entered remain, and transmitters that were
•
previously unknown are successively assigned.
Grade:
39
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
